REDCAT SIXTYFOUR RER32894 Benutzerhandbuch Seite 25

R P
ADIO
Function Settings
Reverse:
The reverse function changes a channel's direction of movement in relation to its input.
1. Press the "OK" key until the desired channel is selected, then use the "UP" and "DOWN"
keys to change setting. Nor = Normal, Rev = Reverse.
2. Hold the "CANCEL" key to save and return to the previous menu.
3. To return to default settings press and hold the "OK" key for 3 seconds, then press and
hold the"CANCEL"key to save.
End Points:
This is THE most important setting and should be set for ALL servos.
This setting can prevent damage to a servo from moving too far in each direction.
The left box is the low end point, the right box is the high end point.
1. Press the "OK" to change channels.
2. Move the channel using the transmitter to select the low or high side.
3. Use the "UP" and "DOWN" keys to increase or decrease the value.
4. Hold the "CANCEL" key to save and return to the previous menu.
5. To return to default settings press and hold the "OK" key for 3 seconds. Press and hold the"CANCEL"key to save.
Display:
This function displays the model's channel output in real time.
Subtrim:
Subtrim changes the center point of the channel. For example, if the steering is out of
alignment, the subtrim could be used to fix this. Keep in mind that adjusting subtrim will
affect your end points. It is recommended that you fine tune your end points, each time you
adjust the subtrim.
1. Press the "OK" to change channels.
2. Use the "UP" and "DOWN" keys to change the subtrim position.
3. Hold the "CANCEL" key to save and return to the previous menu.
4. To return to default settings press and hold the "OK" key for 3 seconds, until the channel
returns to the center. Press and hold the "CANCEL" key to save.
Dual Rate Setup:
The dual rate/exp. Function only applies to channels 1, 3, 4, 5, and 6.
[Dual Rate]: Dual Rate reduces or increases the overall throw of a servo. For example, if you
set the steering dual rate to 50%, the wheels will only steer 50% of their maximum potential
while the steering stick is at 100% full throw.
[Exp. (Exponential)]: Exponential changes the relationship between stick movement and
servo movement by creating a curve. When in use, the stick movement and servo move-
ment are no longer linear. This is used to soften the feels of a channel, or to make it feel
more aggressive.
1. Press the "OK" to change between settings.
2. Use the "UP" and "DOWN" keys to change the channel/rate/exp values, depending on the selected setting.
3. Hold the "CANCEL" key to save and return to the previous menu.
4. To return a setting to default, press and hold the "OK" key for 3 seconds. Press and hold the "CANCEL" key to save.
Throttle Curve:
This function can make the throttle feel softer or more aggressive, using a liner or curved
line. This function uses 5 points to change the throttle curve, L = low and H = high.
1. Press the "OK" to change between points.
2. Use the "UP" and "DOWN" keys to change point position.
3. Hold the "CANCEL" key to save and return to the previous menu.
4. To return a setting to default, press and hold the "OK" key for 3 seconds. Press and hold
the "CANCEL" key to save.
ROGRAMMING
TM
24