REDCAT SIXTYFOUR RER32894 Benutzerhandbuch Seite 23

R P
ADIO
System Settings
Model Reset:
1. Using the "Up" & "Down" keys, select the model and press "OK".
2. The system will ask [Are you sure], use the"Up" & "Down" keys to select [Yes] and press
"OK" again yo confirm.
3. Hold the "Cancel" button for 3 seconds to save and exit.
RX Setup:
1. Using the "Up" & "Down" keys, select the
desired item.
2. Press "OK" to go to that item menu.
RF Standard:
This function allows you to switch RF protocols for use with different receivers.
1. If you are sure you want to change the RF standard, use the "Up" & "Down" keys to select
[Yes] and press "OK".
2. Select [AFHDS 2A] or [AFHDS] then press and hold "OK" for 3 seconds.
3. Use the "Up" & "Down" keys to select a mode then press and hold the "Cancel" key to
save and exit.
Available RF Protocols:
RF Protocol
AFHDS
AFHDS 2A
RX Battery:
Used to change battery monitor settings. Can be set to an external or internal sensor.
There are 4 available settings:
[External sensor/ Internal Sensor]: The system has its own voltage sensor, however it can be
set to [External], for use with an external battery sensor.
[Low]: Sets the battery's [low voltage], see your battery's user manual to determine this
setting.
[Alarm]: Sets the voltage level that the system will alert the user if the battery gets too low.
[High]: Sets the battery's full voltage level.
Failsafe:
This function is used to protect against a runaway vehicle, in the event the model loses signal.
All channels are listed in the failsafe menu. If a channel is set to [Off], in the case of a loss of
signal, that corresponding servo will hold its last received position. If a channel displays a
percentage, the servo will instead move to the selected position.
1. Use "UP" and "DOWN" to choose a channel and press "OK" to enter its failsafe settings.
2. Use "UP" and "DOWN" to turn the failsafe on or off.
3. Move the channels control surface to the desired position and hold the "Cancel" key to confirm and exit.
Sensors List & Choose Sensor:
Changes which sensors are displayed on the home screen.
The home screen can display up to 3 sensors.
1. To add a sensor to the home screen, use the "OK" key to
select a sensor slot, then use the "UP" and "DOWN" keys
to select a sensor.
2. To return to default settings press and hold the "OK" key
for 3 seconds, then press and hold the "Cancel" key to save and exit.
ROGRAMMING
Receiver
R9B, R6B, R6C, GR3E, GR3F
A3, A6, X6, iA4B, iA6, iA6B, iA10, iA10B
TM
22