Function Settings - Redcat Sixtyfour Rer32894 Benutzerhandbuch

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

ADIO

System Settings

Speed and Distance:

This function is for setting up speed and distance sensors. (Sensors not included)

Speed Sensor: If a sensor is connected, use the "UP" and "DOWN" keys to select the desired

sensor, then press and hold the "CANCEL" key to save.

Rotation Length: The distance from the center of the wheel to the distance sensor. Use the

"UP" and "DOWN" keys to enter the length. Press and hold the "CANCEL" key to save.

Note: This feature is experimental, speed sensors have not been implemented for Redcat

vehicles.

Reset Odometer 1 + 2: These settings return the odometer to "0". Select odometer 1 or 2, then press "OK".

The system will display a prompt, select [Yes].

Reset Odometer 1: Resets odometer 1 to "0". Odometer 1 records the distance traveled during a session. Note that restarting the system

will also reset odometer 1.

Reset Odometer 2: Resets odometer 2 to "0". Odometer 2 records the total distance traveled since last reset. The total distance of each

session, over several sessions are be added together.

Output Mode:

PPM is capable of transferring all channels through one physical output.

• When [PWM] is selected, the receiver will output channels 1-6 via channel 1-6.

• When [PPM] is selected, the receiver will output a standard PPM signal via the PPM interface.

To turn the function on press the "UP" or "DOWN" keys. Once the function is on, you can then

press and hold the "CANCEL" key to save and exit.

This function is used to set up the i-BUS module. The i-BUS module can be used to add

servos to your model that may be too far away from the receiver.

1. Use the "UP" and "DOWN" keys to choose a channel and press "OK".

2. Press the button on the i-BUS module that corresponds to the desired output, the system will then return to the previous menu.

3. After setting up the desired channels press and hold the "CANCEL" key to save and exit.

Servo Frequency:

This function sets the frequency that the receiver outputs to the servos. Check your servo's

user manual to find the correct setting.

This should only be changed if you are using different servos than stock.

LCD Brightness:

This function changes the brightness of the LCD screen.