Loading The Stored System Settings - Yamaha RX-V1800 Bedienungsanleitung

Saving and recalling the system settings (SYSTEM MEMORY)
4
Press 3 l / h repeatedly to select the
desired memory number ("MEMORY1" to
"MEMORY6").
SYSTEM MEMORY
. SAVE;;;;;;;MEMORY1
ADAPTIVE DRC;;AUTO
EQUALIZER;;;;;;GEQ
YPAO PEQ;;;;;;NONE
[p]/[[]:
[ENTER]:
Stored system parameters in the
selected memory number
y
• If system settings are already stored in the selected
memory number, the stored system parameter settings
appear in the menu screen. "EMPTY" appears in the menu
screen if no system settings are stored in the selected
memory number.
• If system settings are already saved in the selected
memory number, this unit overwrite the old system
settings.
• If you save the system settings to "MEMORY1" to
"MEMORY4", you can load the stored settings by
pressing the corresponding M SYSTEM MEMORY
buttons (see page 94).
Press 3 ENTER to save the current system
5
settings to the selected memory number.
Press F SET MENU again to exit from "SET
6
MENU".

Loading the stored system settings

• Before performing the following operations, set the
operation mode selector on the remote control to C AMP.
• This unit overwrites the stored settings to the current
settings of this unit. If you do not want to erase the current
settings, save the current settings to any SYSTEM
MEMORY number in advance.
Loading by the M SYSTEM MEMORY
buttons
You can recall the system settings stored in "MEMORY1"
to "MEMORY4" by pressing the corresponding
M
SYSTEM MEMORY buttons.
94
En
Drama
Select
Return
1
M
Press one of the
buttons on the remote control to select the
desired memory number.
"MEMORY 1 LOAD" (example) appears in the front
panel display.
SYSTEM MEMORY
1 2
y
"EMPTY" appears in the menu screen if no system settings
are stored in the selected memory number.
Press the selected M SYSTEM MEMORY
2
button once more to confirm the selection.
This unit loads the settings stored in the selected
memory number.
Loading by the SET MENU operation
Press F SET MENU on the remote control.
1
The top "SET MENU" display appears in the OSD.
2
Press 3 n to select "SYSTEM MEMORY" and
then press 3 ENTER.
The "SYSTEM MEMORY" menu appears in the
OSD.
Press 3 ENTER to select "LOAD".
3
The following menu appears in the OSD.
SYSTEM MEMORY
. LOAD;;;;;;;CURRENT
Church in Freiburg
ADAPTIVE DRC;;AUTO
EQUALIZER;;;;;;PEQ
YPAO PEQ;;;NATURAL
[p]/[[]:
[ENTER]:
4
Press 3 l / h repeatedly to select the
desired memory number where the system
settings are stored and then press
3 ENTER.
This unit loads the selected system settings.
SYSTEM MEMORY
. LOAD;;;;;;;MEMORY6
ADAPTIVE DRC;;AUTO
EQUALIZER;;;;;;PEQ
YPAO PEQ;;;;;;FLAT
[p]/[[]:
[ENTER]:
Press F SET MENU to exit from "SET
5
MENU".
SYSTEM MEMORY
3 4
Select
Return
Straight
Select
Load