Yamaha RX-V1800 Bedienungsanleitung Seite 76

Customizing this unit (MANUAL SETUP)
Input menu 4 INPUT MENU
Note
Some parameters described below may not be available for all input sources and some parameters are only available for specific input
sources.
Parameter
I/O ASSIGNMENT
INPUT RENAME
VOL. TRIM
DECODER MODE
STANDBY CHARGE
BGV
INPUT CH
FRONT
Option menu 5 OPTION MENU
Menu
A)DISPLAY SET
74
En
Assigns the input/output jacks according to the component to be used if the initial settings of
this unit do not correspond to your needs.
Changes the name of the input source that appears in the OSD and in the front panel display.
Adjusts the level of the signal input at each jack.
Switches the decoder activation mode. You can designate the reassigned digital input jacks for
DTS signals.
Selects whether this unit charges the battery of the stationed iPod or not when this unit is in the
standby mode (see page 61).
Selects the video source played back in the background of the sources input at the MULTI CH
INPUT jacks.
Selects the number of channels input from an external decoder.
Selects the analog jacks at which the front channel signals from an external decoder are input
when you set "INPUT CH" to "8CH".
Parameter
DIMMER
Adjusts the brightness of the front panel display.
OSD SHIFT
Adjusts the vertical position of the OSD.
GRAY BACK
Selects whether this unit displays a gray background in your video
monitor when there is no video signal being input.
SHORT MESSAGE
Selects whether this unit displays the short messages on the video
monitor after you perform a certain operation.
ON SCREEN
Sets the time for which the iPod menu is displayed in the OSD after
you perform a certain operation.
FL SCROLL
Selects the mode to display the information of your iPod in the front
panel display.
Functions
Functions
Page
86
86
86
86
87
87
87
87
Page
88
88
88
88
88
89