Muting The Audio Output; Displaying The Input Source Information (Signal Info) - Yamaha RX-V1800 Bedienungsanleitung

Playback

Muting the audio output

Press D MUTE on the remote control to mute the
audio output. Press D MUTE again to resume
the audio output.
y
• You can also rotate Q VOLUME on the front panel or press
B VOLUME +/– on the remote control to resume the audio
output.
• You can adjust the muting level by using the "MUTING TYPE"
parameter in "VOLUME MENU" (see page 81).
• The MUTE indicator flashes in the front panel display when the
audio output is muted and disappears from the front panel
display when the audio output is resumed.
Displaying the input source
information (SIGNAL INFO)
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
Set the operation mode selector to C AMP
1
and then press F SET MENU on the remote
control.
The top "SET MENU" display appears in the OSD.
SET MENU
;AUTO SETUP
. ;MANUAL SETUP
;SYSTEM MEMORY
;SIGNAL INFO
[ ]/[ ]:
[ENTER]:
2
Press 3 n repeatedly to select "SIGNAL
INFO" and then press 3 ENTER.
The audio information about the input source appears
in the OSD.
3
Press 3 l / h to toggle between the audio
and video information displays.
y
The information is also appears in the front panel display.
Press 3k / n repeatedly to change the displayed
information.
Press F SET MENU on the remote control
4
again to exit from "SET MENU".
44
En
UP/DOWN
Enter
Audio information
FORMAT
Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
SAMPLING
The number of samples per second taken from
a continuous signal to make a discrete signal.
CHANNEL
The number of source channels in the input
signal (front/surround/LFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as "3/2/0.1".
BITRATE
The number of bits passing a given point per
second.
DIALOG
The dialogue normalization level preset to the
current input bitstream signal (see page 125).
FLAG
Flag data encoded in the bitstream, or PCM
signals that cue this unit to automatically
switch decoders ("Surround EX", etc.).
Notes
• "–––" appears when this unit cannot display the corresponding
information.
• Some high definition audio bitstream contents may not include
the discrete surround back left and right channel signals but are
encoded at the bitrate of 192 kHz.
• Even if you make settings to output bitstreames directly, some
players convert the Dolby TrueHD or Dolby Digital Plus
bitstreams to the Dolby Digital bitstreams, while converting the
DTS-HD Master Audio or DTS-HD High Resolution Audio
bitstreams to the DTS bitstreams.
Video information
HDMI SIGNAL
HDMI RES.
ANALOG RES.
HDMI ERROR
(HDMI MESSAGE)
Note
"–––" appears when this unit cannot display the corresponding
information.
Type of the source video signals and
the video signals output at the HDMI
OUT jack of this unit.
Resolution of the input signal (analog
or HDMI) and the output signal
(HDMI).
Resolution of the source video signals
and the analog video signals output at
the COMPONENT MONITOR OUT
jacks of this unit.
Error message for HDMI sources or
connected HDMI devices. See
page 120 for details.