Remote Control Operations - Yamaha RX-V1800 Bedienungsanleitung

Using multi-zone configuration
y
• You must complete this step within 10 seconds while the
selected zone flashes in the front panel display. Otherwise,
the currently selected zone mode is automatically
canceled. In this case, press P ZONE CONTROLS
again.
• The initial setting is ZONE2 when both Zone 2 and Zone 3
are turned on.
3
Refer to "Selecting the input source of Zone
2 or Zone 3", "Adjusting the volume level of
Zone 2 or Zone 3", "Adjusting the balance of
the speaker level in Zone 2 or Zone 3" or
"Adjusting the tonal quality of Zone 2 or
Zone 3" on page 111 to perform further
operations.

Remote control operations

Set the operation mode selector to C AMP
1
and then press A SELECT k repeatedly to
select the zone you want to control.
"ZONE 2" or "ZONE 3" is displayed in the display
window (A) on the remote control.
AMP
SOURCE
TV
2
Refer to "Selecting the input source of Zone
2 or Zone 3", "Adjusting the volume level of
Zone 2 or Zone 3", "Adjusting the balance of
the speaker level in Zone 2 or Zone 3" or
"Adjusting the tonal quality of Zone 2 or
Zone 3" on page 111 to perform further
operations.
Press A SELECT k / n to exit from the
3
Zone 2/Zone 3 mode.
110
En
SELECT
or
Turning on or off Zone 2 and/or Zone 3
using the remote control
8 POWER and 7 STANDBY on the remote control
work differently depending on the selected zone that
appears in the display window (A) on the remote control.
• When the main zone, Zone 2 or Zone 3 mode is
selected, you can turn on the main zone, Zone 2 or
Zone 3 or set them to the standby mode individually.
• When the all mode is selected, pressing 8 POWER
turns on the main zone, Zone 2 and Zone 3
simultaneously and pressing 7 STANDBY sets them
to the standby mode simultaneously.
Display window
Control mode
Main zone
Name of the selected
mode input area
"ZONE 2" or "2;name
Zone 2 mode
of the selected input
area"
"ZONE 3" or "3;name
Zone 3 mode
of the selected input
area"
All mode
"ALL"
Notes
• When the remote control is in the main zone mode, "MAIN"
appears for a few seconds when 8 POWER or 7 STANDBY
is pressed.
• "ALL" appears in the display window (A) on the remote
control only when A SELECT n is pressed.
POWER
and
(A)
STANDBY
Turns on the main
zone only or sets it to
the standby mode.
Turns on Zone 2 or
sets it to the standby
mode.
Turns on Zone 3 or
sets it to the standby
mode.
8 POWER: turns on
the main zone, Zone
2 and Zone 3.
7 STANDBY: sets
the main zone, Zone
2 and Zone 3 to the
standby mode.