Yamaha RX-V1800 Bedienungsanleitung Seite 88

Customizing this unit (MANUAL SETUP)
Input/output assignment
I/O ASSIGNMENT
Use this feature to assign the input/output jacks according
to the component to be used if the initial settings of this
unit do not correspond to your needs. Change the
parameter to reassign the respective jacks and effectively
connect more components.
Once the input/output jacks are reassigned, you can select
the corresponding component by using the C INPUT
selector on the front panel (or the input selector buttons on
the remote control).
J) DVR
.
COMPONENT IN;;;[C]
COAXIAL IN;;;;;(3)
OPTICAL IN;;;;NONE
OPTICAL OUT;;;NONE
HDMI IN;;;;;;;;[4]
Current ( DTV/CBL )
[p]/[[]:
[ENTER]:
y
• "NONE" appears in the OSD when any input source is not
assigned to the input/output jack.
• You cannot select a specific item more than once for the same
type of jack.
• An asterisk (*) appears to the right of the input/output jack
names that have been changed from their previous settings.
• The currently assigned input source for the selected input/
output jack appears in the OSD ("Current ( DTV/CBL )" in the
display example above).
Input rename INPUT RENAME
Use this feature to change the name of the input source
that appears in the OSD and in the front panel display.
A) TUNER
INPUT RENAME
TUNER
[p]/[[]:
[ ]/[ ]:
[ENTER]:
[RETURN]:
y
You can also change the name of the input source that appears in
the display window (A) on the remote control. Refer to
"Changing source names in the display window" on page 102.
1
Press 3l / h to place the "_" (underscore)
under the space or the character you want to
edit.
86
En
*
Select
Enter
. TUNER
Position
Character
Enter
Return
2
Press 3k / n to select the character you
want to use and then press 3l / h to move
to the next space.
Notes
• You can use up to 9 characters for each input.
• Press 3 n to change the character in the following order,
or press 3 k to go in the reverse order:
A to Z, 0 to 9, a to z, symbols (#, *, –, +, etc.), space.
3
Repeat steps 1 through 2 to rename each
input source.
Press 3 ENTER to complete.
4
Volume trim VOL. TRIM
Use this feature to adjust the level of the signal input at
each jack. This feature is useful if you want to balance the
level of each input source to avoid sudden changes in
volume when switching between input sources.
Control range: –6.0 dB to +6.0 dB
Control step: 0.5 dB
Initial setting: 0.0 dB
A) TUNER
INPUT RENAME
.
VOL. TRIM;;;;+6.0dB
[ ]/[ ]:
[p]/[[]:
y
This parameter also affects the signals output at the audio ZONE
OUT jacks.
Decoder mode DECODER MODE
Use this feature to switch the decoder mode. You can
designate the reassigned digital input jacks for DTS
signals.
D) CD
I/O ASSIGNMENT
INPUT RENAME
VOL. TRIM;;;;;0.0dB
.
DECODER MODE;;;AUTO
[ ]/[ ]:
[p]/[[]:
Choice
AUTO
Automatically detects digital audio signal input
types and selects the appropriate decoder.
DTS Activates the DTS decoder when digital audio
signals are input.
UP/DOWN
Adjust
UP/DOWN
Select
Functions