Yamaha RX-V1800 Bedienungsanleitung Seite 40

Optimizing the speaker setting for your listening room
Press 3 ENTER to start the setup
4
procedure.
This unit starts the automatic setup procedure. Loud
test tones are output from each speaker during the
automatic setup procedure. Once all items are set, the
result display appears in the OSD.
Notes
• During the automatic setup procedure, do not perform any
operation on this unit. If you perform any operation while
this unit is in the automatic setup procedure, "E-9:USER
CANCEL" appears in the OSD. In such cases, select
"RETRY" to restart the automatic setup procedure.
• We recommend that you get out of the room while this unit
is in the automatic setup procedure. Keep quiet when you
leave the room. It takes approximately 3 minutes for this
unit to complete the automatic setup procedure.
The display changes as follows.
AUTO SETUP
SETUP;;;;;;;;;AUTO
WIRING;;;;;;;CHECK
DISTANCE;;;;;CHECK
SIZE;;;;;;;;;CHECK
EQ;;;;;;;;;NATURAL
LEVEL;;;;;;;;CHECK
.
START
[ ]/[ ]:
[ENTER]:
AUTO SETUP
INITIALIZING
.
PRE CHECK
MAIN CHECK
EQUALIZING
LEVEL
||||||||;;;;;;;;;;
[ ]
AUTO SETUP
.
RESULT
SP :
DIST:
LVL : -10.0/+5.0dB
>SET
[ ]/[ ]:
[ENTER]:
38
En
UP/DOWN
Start
: EXIT
5/4/0.1
3.60/4.30m
CANCEL
UP/DOWN
Detail
The results displayed under "RESULT" are as follows.
Number of speakers SP
Displays the number of speakers connected to this
unit in the following order:
Front/Back/Subwoofer
Speaker distance DIST
Displays the speaker distance from the listening
position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level LVL
Displays the speaker output level in the following
order:
Lowest speaker output level/Highest speaker output
level
Notes
• If "E-10:INTERNAL ERROR" appears during the testing
procedure, restart from step 2.
• If an error occurs during the automatic setup procedure,
the setup procedure is canceled and an error screen
appears. For details, see "If an error screen appears" on
page 41.
• When this unit detects potential problems during the
automatic setup procedure, "WARNING" and the number
of warning messages appears in the above of "RESULT"
(see page 41).
• Depending on the listening environment, "SWFR
PHASE:REV" appears during the automatic setup
procedure and "SUBWOOFER PHASE" in "SOUND
MENU" (see page 79) is automatically set to
"REVERSE".
Press 3 ENTER to display the setup results
5
in detail.
AUTO SETUP
.
RESULT
SP
DIST:
LVL : -10.0/+5.0dB
>SET
[ ]/[ ]:
[ENTER]:
RESULT
FRONT L;;;;;OK
[p]/[[]:
[ENTER]:
: 5/4/0.1
3.60/4.30m
CANCEL
UP/DOWN
Detail
WIRING
Select
Return