Connecting Speakers - Yamaha RX-V1800 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für RX-V1800:

Inhaltsverzeichnis

Verfügbare Sprachen

Connecting speakers

Be sure to connect the left channel (L), right channel (R), "+" (red) and "–" (black) properly. If the connections are faulty,

this unit cannot reproduce the input sources accurately.

• Before connecting the speakers, make sure that this unit is turned off (see page 33).

• Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could

damage this unit and/or speakers.

• Use magnetically shielded speakers. If this type of speaker still creates interference with the monitor, place the

speakers away from the monitor.

• If you are to use 6-ohm speakers, be sure to set "SPEAKER IMP." to "6Ω MIN" before using this unit (see

page 33). You can also use 4-ohm speakers as the front speakers (see page 113).

• A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a

stripe, groove or ridge. Connect the striped (grooved, etc.) cable to the "+" (red) terminals of this unit and your speaker. Connect the

plain cable to the "–" (black) terminals.

• You can use the SP1 terminals to connect the Zone 2 or Zone 3 speakers as well as the presence speakers (see page 108).

• You can connect both surround back and presence speakers to this unit, however they do not output sound simultaneously. This unit

automatically switches the presence speakers and surround back speakers depending on the input sources and the selected sound field

programs. You can set to prioritize either set of speakers using the "PRIORITY" parameter in "MANUAL SETUP" (see page 79).

For the 7.1-channel speaker setting

Surround back speakers

Surround speakers

Presence speakers

PRESENCE/ZONE 2/ZONE 3

SURROUND BACK/

Front speakers

Center speaker

ZONE 2/ZONE 3

Zone 2 or Zone 3

(see page 108)

Inhaltsverzeichnis