If An Error Screen Appears - Yamaha RX-V1800 Bedienungsanleitung

If an error screen appears

Press 3 l / h to select "RETRY" or "EXIT" and
then press 3 ENTER.
The following display is an example where "E-9:USER
CANCEL" appears in the OSD.
ERROR
E-9:USER CANCEL
Don't operate
any function
.
>RETRY
[p]/[[]:
[ENTER]:
Choices: RETRY, EXIT
• Select "RETRY" to retry the "AUTO SETUP"
procedure.
• Select "EXIT" to exit from the "AUTO SETUP"
procedure.
y
• If "E-5:NOISY" appears in the OSD, you can also select
"PROCEED" and let this unit continue the automatic setup.
However, we recommend that you perform the automatic setup
procedure again for more accurate adjustment.
ERROR
E-5:NOISY
Keep silent
. >RETRY EXIT PROCEED
[p]/[[]:
[ENTER]:
• If "E-10:INTERNAL ERROR" appears in the OSD, you can
select only "EXIT".
• For details about each error message, refer to the "AUTO
SETUP" section in "Troubleshooting" on page 123.
If "WARNING" appears
When this unit detects potential problems during the
automatic setup procedure, "WARNING" appears in the
result display. Check the warning messages to correct your
speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the
"AUTO SETUP" procedure.
EXIT
Select
Enter
Select
Enter
Optimizing the speaker setting for your listening room
1
Make sure the pointer is pointing at
"WARNING" and then press 3 ENTER to
display the detailed information about the
warning.
The number on the right of "WARNING" indicates
the number of warning messages.
AUTO SETUP
WARNING 2
. RESULT
SP :
DIST:
LVL : -10.0/+5.0dB
>SET
[ ]/[ ]:
[ENTER]:
2
Press 3 l / h repeatedly to toggle between
the warning displays.
WARNING
W-1:OUT OF PHASE
Reverse channel
FL
CENTER
---
SL
SBL
[p]/[[]:
[ENTER]:
y
• For details about each warning message, refer to the
"AUTO SETUP" section in "Troubleshooting" on
page 123.
• When the corresponding warning message is not
applicable to a speaker, "–––" is displayed instead.
• If the volume level setting of the connected subwoofer is
too high or low, "TOO LOUD" (the volume level setting is
too high) or "TOO LOW" (the volume level setting is too
low) is displayed in the "W-3:LEVEL ERROR" display.
Adjust the volume level setting of the connected
subwoofer appropriately.
WARNING
W-3:LEVEL ERROR
---
CENTER
PL
---
---
SWFR:TOO LOUD
[p]/[[]:
[ENTER]:
Press 3 ENTER to return to the top result
3
display.
y
The adjustment are made even if "WARNING" appears, however
the adjustment may not be optimal.
5/4/0.1
3.60/4.30m
CANCEL
UP/DOWN
Detail
---
PR
---
---
Select
Return
FR
---
SR
SBL
Select
Return
41
En