Yamaha RX-V1800 Bedienungsanleitung Seite 109

Press L LEARN using a ballpoint pen or
2
similar object.
"LEARN" and the selected component name
(e.g. "DVD") appear alternately in the display
window.
LEARN
Notes
• Do not press and hold L LEARN. If you hold it down for
more than 3 seconds, the remote control enters the remote
control code setting mode.
• If you do not complete each of the following steps within
30 seconds, the learning mode will be automatically
canceled. In this case, start over from step 2.
Press and hold L CLEAR using a ballpoint
3
pen or similar object and then press the
button you want to clear for about 3 seconds.
"C;OK" appears in the display window (A) if
clearing was successful. Once "C;OK" appears in the
display window on the remote control, release the
ballpoint pen or similar object used to press
L CLEAR to exit the clearing mode. The remote
control returns to the learning mode.
MODE – PTY SEEK – START
LEARN CLEAR RENAME
y
• If you continuously want to clear another function, repeat
step 4.
• If you continuously want to clear another function for
another component, press A SELECT k / n to select the
input area, then repeat step 3.
• Once you clear a learned function, the button reverts to the
factory setting (or to the manufacturer setting if you have
set remote control codes).
Press L LEARN again to exit.
4
Notes
• "C;NG" appears in the display window (A) on the remote
control if clearing was unsuccessful. In this case, start over from
step 2.
• "ERROR" appears in the display window (A) if you press
more than one button simultaneously.
Clearing a macro function
You can clear the function programmed for a certain
macro button.
Set the operation mode selector to C AMP or
1
C SOURCE and then press L MACRO using
a ballpoint pen or similar object.
"MCR ?" appears in the display window (A) on the
remote control.
AMP
SOURCE
TV
or
AMP
SOURCE
TV
Note
If you do not complete each of the following steps within 30
seconds, the macro programming mode will be
automatically canceled. In this case, start over from step 1.
Press and hold L CLEAR using a ballpoint
2
pen or similar object, then press the macro
button you want to clear for about 3 seconds.
"C;OK" appears in the display window (A) on the
remote control if clearing was successful.
MD/TAPE DVD BD/HD DVD PHONO
DTV/CBL DVR VCR V-AUX/DOCK
OFF ON MACRO LEARN CLEAR RENAME
y
• If you continuously want to clear another function, repeat
step 2.
• Once you clear a programmed function, the button reverts
to the factory setting (or to the manufacturer setting if you
have set remote control codes).
Press L MACRO again to exit the macro
3
programming mode.
Notes
• "C;NG" appears in the display window (A) on the remote
control if clearing was unsuccessful. In this case, start over from
step 2.
• "ERROR" appears in the display window (A) on the remote
control if you press more than one button simultaneously.
Remote control features
MACRO
107
En