Editing A Frequency List - SMART Smartmeter C10 Bedienungsanleitung

Using the Meter
12. See point 4 to search for channels on other transponders. The channels
found will be added to the channel list.
)
5.1.3

Editing a Frequency List

1. Press the MENU key.
2. Use the keys
selection with the OK key. The search window will open. A list of the saved
frequencies will be stored under the frequency menu item. Using the
keys you can select the individual frequencies.
5.1.3.1 Deleting a Frequency from the List
3. Using the keys
lete from the list in the search window under the menu item frequency.
4. Press the F1 key. A message will appear asking if you are sure you want to
delete this frequency.
5. Using the keys
pressing the OK key once again.
5.1.3.2 Adding a Frequency to the List
1. Press the F2 key in the
search window. The following input
mask will open:
2. Using the numeric keypad, adjust the frequency value or select one from the
default values using the keys
3. Use the key to then enter the symbol rate and adjust this to the current
value using the numeric keypad or select one from the default values using
the and keys.
4. Use the key to then enter the QAM mode and select from the default val-
ues using the
64
If, during the input of the frequency, symbol rate and QAM
mode a channel is found, an audible signal will sound. You
can adjust this under Signal Audio Tone in the menu set-
tings. You can also adjust the volume of the audible signal
under Volume (see chapter 5.5 Settings, page 68).
/ and / to select FREQ SEARCH and confirm your
and , select the frequency which you would like to de-
and , select the YES box and confirm your selection by
and
and keys.
.
/
smartmeter C10