Technical Data; Remaining Hazards - Scheppach Basa4 Originalbetriebsanleitung

• When cutting round timber, use a suitable holding
device to prevent the workpiece turning.
• Never use guards to lift or transport items.
• Ensure that the bandsaw blade guards are used and
correctly adjusted.
• Keep your hands a safety distance away from the
bandsaw blade. Use a push stick for narrow cuts.
• The push stick has to be stored on the intended de-
vice, so that it can be reached from normal working
position and is always ready to be used.

6. Technical data

Alternating
Motor current
230-240 V
1,5 kW (S1)
Power 1,8 kW
(S6 40%)
Revolutions
Saw band
length
Saw band width
Saw band width
max.
Cutting speed
Passage height
Passage width
Table size
Slewing range
of the table
Max. size of the
workpiece
Overall weight
Subject to technical modifications!
The work piece must have a minimum height of 3 mm
and a minimum width of 10 mm.
Noise data
The noise level defined in EN ISO 3746 and EN 1807
respectively (correction factor k3 calculated in acc.
with Appendix A.2 of EN 1807-1) for the noise emission
values determined for workplace noise level reflect the
workplace conditions defined in ISO 7960 Appendix J.
32 | GB
Rotary current
400 V 3phase
1,5 kW (S1)
1,8 kW
(S6 40%)
1480 min
-1
2895 mm
6-25 mm
25 mm
700-1000 m/min
250 mm
375 mm
400 x 548 mm
-17 °/+45 °
375 x 250 mm
98 kg
www.scheppach.com
The values stated are emission values and are there-
fore not necessarily safe operating values. Although
there is a correlation between emission and immission
levels, you cannot reliably deduce from this whether
additional safety measures are required or not. Fac-
tors which can influence the immission level currently
at the workstation comprise the duration of the effects,
the characteristics of the work room, other sources of
noise etc., for example, the number of machines and
adjacent operations.
The permissible values per workstation can also vary
from country to country. This information should never-
theless enable the user to make a better estimation of
dangers and risks.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
Die Einwirkung von Lärm kann Gehörverlust bewirken.
7.

Remaining hazards

The machine has been built using modern technology
in accordance with recognized safety rules. Some re-
maining hazards, however, may still exist.
• Risk of injury for fingers and hands by the rotat-
ing saw band due to improper handling of the work
piece.
• Risk of injury through the hurling work piece due
to improper handling, such as working without the
push stick.
• Risk of damaging your health due to wood dust and
wood chips. Wear personal protective cloth such as
goggles. Use a fitting dust extractor.
• Risk of injury due to defective saw band. Regularely
check saw band for such defects.
• Risk of injury for fingers and hands while changing
saw band. Wear proper gloves.
• Risk of injury due to starting saw band while switch-
ing on the machine.
• The use of incorrect or damaged mains cables can
lead to injuries caused by electricity.
• Danger to health from running saw band due to long
hair and loose clothing. Wear personal protective
equipment such as a hair net and close-fitting work
clothing.
82,9 dB
4 dB
100,2 dB
4 dB