Drip Tray And Grid; Cleaning The Steam And Hot Water Nozzles - Profitec Ride Bedienungsanleitung

2. Use the other hand to remove the silicone attachment from the holder.
Cleaning the filters, silicone attachments, and portafilter
1. Remove the silicone attachment and filter from the portafilter as
explained in the previous sections.
2. Clean the portafilter, silicone attachment, and filter with warm water, a
food-safe washing-up liquid, and a soft cloth.
3. Allow the filter, silicone attachment, and portafilter to dry completely.
4. Install the silicone attachment and filter in the portafilter (see Chapter
9.6, „Inserting the silicone attachments and filters in the portafilter").
11.2

Drip tray and grid

CAUTION
Risk of injury due to sharp edges
The edges of the drip tray and grid are sharp and may cause injuries.
• Avoid pressing too hard on the edges.
• Wipe over the edges carefully.
Empty the drip tray in good time. Do not wait until it is full to the brim.
Clean the drip tray, grid, and cup raiser daily. Do not put them in the dishwasher.
1. Pull the drip tray forwards out of the machine. Remove the grid from the
drip tray.
2. Empty the drip tray over a sink.
3. Clean all parts with warm water, a food-safe washing-up liquid, and a
soft cloth.
4. Allow all parts to dry fully.
5. Install all parts in reverse order.
11.3

Cleaning the steam and hot water nozzles

WARNING
Risk of injury
There is a risk of injury when cleaning the steam and hot water nozzles due
to high temperatures.
• Do not touch the steam wand, steam nozzle, hot water wand, or hot
water nozzle. Only touch them via the rubber handles.
EN - 138 RIDE_BA_V1.0