Connecting And Switching On The Machine; Filling The Boiler With Water (Fill Mode) - Profitec Ride Bedienungsanleitung

8.1

Connecting and switching on the machine

1. Remove the water tank (1, Fig. 5) and clean it thoroughly (see Chapter
11.5, „Cleaning the water tank").
2. Fill the water tank with water and insert it back into the machine (see
Chapter 9.4, „Filling the water tank with water").
3. Plug the mains plug into the socket.
4. Press the on/off button (2, Fig. 5).
The LED ring of the on/off button lights up and the "Fill" icon appears on
¾
the display.
8.2

Filling the boiler with water (fill mode)

1. Place a receptacle under the brew group (5, Fig. 5). The opening of the
receptacle should be at least as big as the brew group.
2. Move the brew lever (6, Fig. 5) nto the drawing position (see Chapter
5.2.3, „Operating levers").
The pump starts to fill the brew boiler.
¾
3. Leave the brew lever in the drawing position for at least 30 seconds.
When water comes out of the brew group, this means that the brew
¾
boiler is full.
4. Move the brew lever into the starting position (see Chapter 5.2.3,
„Operating levers").
The "Fill" icon disappears from the display and the steam boiler is filled.
¾
5. Wait until you cannot hear any more pump noise.
The steam boiler is full and the machine starts to heat up the boilers.
9
The "Heating Up" icon appears on the display. After the boilers have
heated up, the brew temperature is shown on the display. The machine
is ready to use.
EN - 107 RIDE_BA_V1.0