Stihl iMOW 3.0 Gebrauchsanleitung Seite 62

English
If the robot mower identifies a blocked-off
area (3), it will slow down and then continue to
move in a different direction.
In mowing operation, the robotic mower leaves
the docking station by itself and mows the lawn.
The robotic mower is operated by the
®
MY iMOW app and the buttons in the control
panel on the robotic mower. Light strips and the
matrix display on the robotic mower as well as an
artificially generated voice output provide infor‐
mation about the current status of the robotic
mower.
4
If the battery's state of charge is low, the robotic
mower will search for the nearest guide wire (4)
during the mowing operation. After recognizing
the guide wire (4), the robotic mower will return
to the docking station by itself. The docking sta‐
tion recharges the battery. The guide wire (4)
must be installed in the mowing area. If the mow‐
ing operation is canceled or the battery must be
charged, the robotic mower can be sent directly
back to the docking station using the MY iMOW
app or HOME pushbutton.
A
5
B
Up to three starting points (5) can be specified
on a guide wire (4). The robotic mower can move
specifically to the respective starting point and
start mowing from there.
The mowing area can be divided into several
zones (example: A and B) by the guide wire (4).
The zones are defined by a starting point (5).
The robotic mower can be directed from the
selected starting point to the left or right into the
desired zone. The robotic mower can then mow
62
6 Preparing the Mowing Area and Robot Mower for Operation
®
4
specifically in the selected zone. The starting
points and zones are managed in the
®
MY iMOW app and can be taking into account
in the mowing plan.
If there is a confined section (6) in the mowing
area, the robotic mower navigates the confined
area, provided that a particular minimum width is
maintained between the perimeter wires. If the
minimum distance cannot be maintained, a guide
wire (7) must be routed through the confined
section (6). The guide wire (7) then guides the
robotic mower directly through the confined sec‐
tion (6) to a starting point (8). From the starting
point (8), the robotic mower can mow the mow‐
ing area behind the confined section (6). How
often the robotic mower returns to the starting
point (8) can be managed by the MY iMOW
and taken into account in the mowing plan.
6 Preparing the Mowing Area
and Robot Mower for Oper‐
ation
6.1 Planning and preparing mow‐
ing areas
Plan and prepare the mowing area prior to com‐
missioning the robot mower. This enables a
robust installation and smooth operation and
eliminates potential sources of interference.
Planning mowing surfaces
► Familiarize yourself with the descriptions
about the docking station and wire routing in
the following sections.
► Transfer the information to your own garden:
– Outline of the mowing area
– Position of the docking station
– Routing of the perimeter wire (note descri‐
bed distances to the edges and wire routing
cases)
– Routing of the guide wire
6
7
8
®
app
0458-074-9601-A