Stihl iMOW 3.0 Gebrauchsanleitung Seite 87

17 Transporting
► Press STOP (1).
The robot mower is stopped and locked.
► Press and hold STOP (1) until the light
strip (2) fully lights up red.
► Press STOP (1).
The light strip (2) flashes twice. The device
lock of the robotic mower is activated. The
robotic mower can be transported, stored,
cleaned or serviced.
17 Transporting
17.1 Transporting the robot mower
► Stop the robot mower and activate the device
lock.
Carrying the robot mower
1
► Wear work gloves made of robust material.
► Carry the robot mower at the front grip sur‐
face (1) and the rear grip surface (2).
Transporting the robot mower in a vehicle
► Secure the robot mower so that it does not tip
over and cannot move.
17.2 Transporting the Battery
The battery has been installed in the robot
mower and must only be removed by a STIHL
authorized dealer.
► Check that the battery is in a safe condition.
► Pack the battery in packaging in such a way
that it cannot move inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Danger‐
ous Goods regulations. The battery is classified
as UN 3480 (lithium ion batteries) and has been
tested pursuant to UN Manual Tests and Criteria
Part III, Subsection 38.3.
The transport regulations can be found at
www.stihl.com/safety-data-sheets.
0458-074-9601-A
18 Storing
18.1
STIHL recommends when the robotic mower is
not used for longer periods of time, e.g., winter
break, to put it into "hibernation". "Hibernation"
deactivates all unnecessary extra functions of
the robotic mower and ensures a low discharge
of the battery.
► If the "Access functions" have been activated
in the "MY iMOW
"Access functions".
► If the robotic mower's state of charge is below
50%: charge the robotic mower until its state
of charge exceeds 50%.
2
► Remove the robotic mower from the docking
station.
Press the following key combination one after the
other:
► Press STOP (1).
The robot mower is stopped and locked.
► Press and hold STOP (1) until the light
strip (2) fully lights up red.
► Press STOP (1).
The light strip (2) flashes twice. The device
lock of the robotic mower is activated.
► Press and hold STOP (1) until the light
strip (2) fully lights up red and finally flashes
red twice.
The hibernation mode is activated. All extra
functions are deactivated.
After the winter break, the robot mower must be
activated so that it is operational again:
► Move robotic mower to the mowing area.
► Press START (3).
The "hibernation" mode is deactivated and the
robotic mower is once again operational.
► If the robotic mower does not respond, it must
be charged: Charging the robotic mower
12.1.
Preparing the robotic mower for
storage
®
" app: Deactivate the
English
1
2
3
87