Connecting The Earthing - Auerswald COMpact 5000R Inbetriebnahmeanleitung

Preparation (COMpact 5000R)
1.
Push the casing into the rack.
2.
Fasten the casing to the right and to the left with the brackets and the four
screws.

Connecting the Earthing

Requirements
– Tools and material:
– Earth wire in the immediate vicinity of the installation site (potential com-
pensation bar of the house installation or protective earth conductor)
Warning: Touching live conductors or telephone connections may cause
life-threatening electrical shocks.
1.
Connect the connecting cable to the potential compensation bar of the
house installation or the protective earth conductor.
2.
Guide the connecting cable to the rear side of the casing.
3.
Join the grommet to the connecting cable and attach it to the earthing ter-
minal. See
82
Screw driver (Phillips)
Connecting cable with at least 2.5 mm
Grommet (ring-shaped cable shoe: insulated or non-insulated) with an
inner ring diameter of 4 mm min. and 6 mm max.
Mount the PBX in the immediate vicinity of an earth wire (potential com-
pensation bar of the house installation or protective earth conductor).
Connect the PBX's earth connection to the earth wire with a connecting
cable whose conductor diameter is at least 2.5 mm
Only a fixed installation is allowed for the connection of the earthing ter-
minal of the PBX to the potential compensation bar of the house instal-
lation or the protective earth conductor. Plug connections are not
allowed.
Fig. 15 on page
²
conductor cross-section
83.
COMpact 5000/R - Firmware Version 6.2 - Setup V01 03/2014
²
.