Ethernet Port - Auerswald COMpact 5000R Inbetriebnahmeanleitung

Important Information
PBX is operated over an analogue connection must be configured after the
device has been put into operation. Germany is the original factory setting.
Furthermore, it is possible to connect to an analogue GSM gateway.

Ethernet Port

Via the Ethernet port, the PBX is connected to a network (for a number of appli-
cations) or to a single PC (only for configuration purposes).
The applications listed at the end do not exclude each other.
For Internet telephony (VoIP), the PBX can be connected to the Internet via a
router. The PBX can manage 100 VoIP accounts for up to 20 different VoIP pro-
viders: The PBX supports two different types of VoIP account:
For internal IP telephony, VoIP end devices can be connected to the PBX via a
switch/router. The PBX supports the following end devices (system telephones
recommended):
Important: Note that many standard VoIP end devices can only use the
functions of the PBX to a very limited extent.
For various audio, switching and door functions several accessories can be
connected to the PBX via a switch/router.
The PBX supports the following IP switchboxes from other manufacturers:
58
VoIP accounts with one or more VoIP phone numbers (similar to the
point-to-multipoint connection on ISDN)
VoIP accounts with a DDI number block (similar to the PBX connection
under ISDN), based on the SIP-DDI feature (also known as SIP trunking)
COMfortel 1400 IP/2600 IP system telephones
COMfortel 3200/3500 system telephones (as of firmware version 1.8A)
COMfortel VoIP 2500 AB system telephones (as of firmware version
4.4I)
COMfortel DECT IP1040 Bases for COMfortel DECT 900C and some
GAP capable DECT handsets from other manufacturers (for further
information see www.auerswald.de)
IP DECT single- and multi-cell servers COMfortel WS-400 IP and COM-
fortel WS-650 IP for COMfortel M-100 and COMfortel M-200 DECT
handsets
Standard VoIP telephones (SIP), e. g. COMfortel 1200 IP)
Soft phones (SIP)
NETIO 230B
WebRelay (identical to Keil)
COMpact 5000/R - Firmware Version 6.2 - Setup V01 03/2014