Preparation
Connecting the Receiver
Insert the RJ-10 connector at the longer, plane end of the spiral cord into
1.
the socket labelled with
Guide the cable to the outside using the corresponding cable channel.
2.
Insert the other RJ-10 connector of the spiral cord into the socket on the re-
3.
ceiver.
Important Information on the Location of the Telephone
Requirements
–
Existing connections close to where the telephone is placed:
i
i
38
Output socket on the router or an existing network mains outlet with PoE
support
If PoE is not supported, a mains socket for the PoE Injector available as
an accessory
on the bottom of the telephone.
COMfortel 1200 IP - Setup V03 09/2016