Warning: Liquid penetrating the casing may cause a life-threatening elec-
tric shock and can damage or destroy the PBX.
Warning: Damaged connection lines as well as damage to the casing and
to the PBX can cause life-threatening electrical shocks.
Warning: Power surges, which can occur during electrical storms, can
cause life-threatening electric shocks and can damage or destroy the PBX.
COMpact 5000/R - Firmware Version 6.2 - Setup V01 03/2014
Working close to active parts is only permitted if these parts are voltage-
free or are protected against direct contact.
Pull out the power plug of the PBX before commissioning a qualified
electrician to open the casing to install an expansion module or perform
switching or connecting services.
Remove any voltage from the device by discharging any capacitors
present, if necessary. In the case of a malfunction, the electrolytic
capacitor for the switch-mode power supply can remain charged for a
long time even after being turned off.
If available, also disconnect the devices from auxiliary power sources
(for example, UPS).
Do not make any structural changes to the device.
For some installation and maintenance work, it is necessary to open the
PBX while it is in operation (qualified electrician only). Make sure that
the PBX is never left unattended while working with an open casing.
Be sure to follow the relevant regulations when handling 230 V system
voltage and devices attached to the mains.
Only operate the device when the casing is closed.
Only operate the device when it is mounted on the wall (COMpact 5000)
or securely fastened in a 19" rack (COMpact 5000R).
Only operate the PBX in closed, dry rooms.
Only clean the device with a soft moist cloth or anti-static cloth.
Only connect the device connection cable with sockets that are
designed for that purpose.
Make sure that the Schuko socket for connecting the PBX is properly
connected (according to VDE 0100). The power socket must be located
near the PBX and be freely accessible at all times.
Replace damaged connection lines immediately.
Use original components and original spare parts only.
Always have a professional carry out repairs immediately. Please con-
tact your qualified electrician or the manufacturer directly.
For this reason, do not mount the PBX during an electrical storm. Avoid
disconnecting and connecting lines during an electrical storm.
Important Information
51