Scheppach HM80L Originalbetriebsanleitung Seite 40

14. Troubleshooting
Fault
Motor does not work
The motor starts up slowly
and does not reach operat-
ing speed.
Motor makes excessive
noise
The motor does not reach its
full power.
Motor overheats easily.
Saw cut is rough or wavy
Workpiece pulls away and/
or splinters
40 | GB
Possible cause
Motor, cable or plug defective,
fuses burnt
Voltage too low, coils damaged,
capacitor burnt
Coils damaged, motor defective
Circuits in the network are over-
loaded (lamps, other motors,
etc.)
Overloading of the motor, insuffi-
cient cooling of the motor
Saw blade dull, tooth shape
not appropriate for the material
thickness
Excessive cutting pressure and/
or saw blade not suitable for use
www.scheppach.com
Remedy
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the
voltage. Arrange for inspection of the motor
by a specialist. Arrange for replacement of the
capacitor by a specialist
Arrange for inspection of the motor by a
specialist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Re-sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade