Salicru SPS ADVANCE R2 Betriebsanleitung Seite 56

Models.
Available power ratings (VA / W).
Audible noise at 1 m in battery mode.
Operating temperature.
Storage temperature with batteries.
Storage temperature without batteries.
Working altitude.
Relative humidity.
Protection rating.
Dimensions (mm)
Depth × Width × Height.
Weight (kg).
Safety.
Electromagnetic compatibility (EMC).
Operation.
Marking.
Quality system.
Tab. 15. ADVANCE T general technical specifications.
9.2. GLOSSARY.
AC.- Alternating current is electric current in which the mag-
•
nitude and direction vary cyclically. The waveform of the most
commonly used alternating current is that of a sine wave, since
this achieves a more efficient transmission of energy. In cer-
tain applications, however, other periodic waveforms are used,
such as triangular or square.
Bypass.-
Manual or automatic, this is the physical connection
•
between the input of an electrical device and its output.
DC.- Direct current is the continuous flow of electrons through
•
a conductor between two points with different potential. Un-
like AC, in DC, electrical loads always circulate in the same
direction from the point of greatest potential to the lowest. Al-
though DC is commonly identified as a continuous current (for
example, that supplied by a battery), any current that always
maintains the same polarity is continuous.
DSP.- Digital signal processor. A DSP is a processor or micro-
•
processor-based system that has a set of instructions, hard-
ware and optimised software for applications that require
numerical operations at very high speed. Because of this, it
is especially useful for the processing and representation of
analogue signals in real time: in a system that works in this
way (real time) samples are usually received from an analogue/
digital converter (ADC).
Power factor.-
•
as the ratio between active power, P, and apparent power, S,
or as the cosine of the angle formed by the current and voltage
factors, designated in this case as cos f , where f is the value of
the angle.
GND.-
This stands for GROUND or EARTH and, as the name
•
indicates, refers to the potential of the surface of the Earth.
EMI filter.-
Filter capable of significantly reducing electromag-
•
netic interference (EMI), which is the disturbance that occurs
in a radio receiver or in any other electrical circuit caused by
56
UPS modules.
Optional battery module.
UPS modules.
UPS modules (B1).
Optional battery module.
The power factor, PF, of an AC circuit is defined
850VA / 595W 1000VA / 700W
< 45 dB
2,400 masl (power degradation up to 5,000 m)
327 x 140 x 191
-
11.8 13.5
- 8.3
- 10.2
ISO 9001 and ISO 140001 (certified by SGS)
electromagnetic radiation coming from an external source.
Electromagnetic interference is also known as radio frequency
interference (RFI). This disturbance can interrupt, degrade or
limit the performance of the circuit
IGBT.-
•
device that is generally used as a controlled switch in power
electronics circuits. This device possesses the characteristics
of the gate signals of field effect transistors with the capacity
for high current and low saturation voltage of the bipolar tran-
sistor, combining an isolated FET gate for input and control and
a bipolar transistor as a single switch in a single device. The
IGBT's excitation circuit is similar to that of the MOSFET, while
the conducting characteristics are similar to those of the BJT.
Interface.-
•
an interface (electronics) is the port (physical circuit) through
which signals are sent or received from one system or sub-
system to another
kVA.-
•
electrical current. In DC, it is practically equal to real power
but, in AC, it can differ from this depending on the power factor.
LCD.-Liquid crystal display, a device invented by Jack Janning,
•
who was an employee of NCR. It is an electrical system for
data presentation formed by 2 transparent conductive layers
and a special crystalline material in the middle (liquid crystal)
which have the ability to orientate light as it passes through.
LED.-
•
emits light that is almost monochromatic, that is to say, it has a
very narrow spectrum when it is polarised directly and is pen-
etrated by an electric current. The colour (wavelength) depends
on the semiconductor material used in the construction of the
diode, and can vary from ultraviolet, passing through the vis-
ible light spectrum, to infrared, the latter called IRED (infra-red
emitting diode).
ADVANCE T
1500VA / 1050W 2000VA / 1400W
0..+40ºC
–20..+50 ºC
–20..+70 ºC
0..90 % non-condensing.
IP20
327 x 140 x 191
14.4 14.4
10.2 12.5
10.2 10.2
EN IEC 60240-1
EN IEC 60240-2
EN-IEC 62040-3
CE
An insulated gate bipolar transistor is a semiconductor
In electronics, telecommunications and hardware,
A volt-ampere is the unit used for apparent power in
Light-emitting diode, a semiconductor device (diode) that
3000VA / 2100W
< 50 dB
416 x 196 x 342
416 x 196 x 342
27.6
22.1
31.5
SALICRU