Salicru SPS ADVANCE R2 Betriebsanleitung Seite 49

7. CONTROL PANEL WITH LCD
DISPLAY.
7.1. COMPOSITION OF THE CONTROL
PANEL WITH LCD DISPLAY.
The control panel consists of:
•
Two buttons with the functions described in Tab. 6.
ˆ
An LCD display with backlighting.
ˆ
SPS Advance R display.
Fig. 12. View of the SPS ADVANCE R2 control panel.
7.2. GENERAL INFORMATION.
7.2.1. Information represented by the display.
Information on input
voltage, battery % and
backup time (backup for
B1 devices not shown)
Information on bat-
tery charge level (each
segment is equivalent
to 25%)
Fig. 14. Graphic and textual information shown on the display.
USER MANUAL
ON/OFF
Information on normal Information on battery
operation operation (cut in supply)
SPS Advance T display.
ON/OFF
Fig. 13. View of the SPS ADVANCE T control panel.
Button
- Starting up the UPS.
With the UPS off, press the button for at least 2 s
ON/OFF
- Shutting down the UPS.
With the UPS on, press the button for at least 2 s
- Reading the parameters.
By pressing the button, the following is displayed cyclically:
- input and output voltage
- backup time
- % level of battery charge and % level of the loads.
- Muting the alarm.
Press the button for at least 3 seconds to mute or unmute
the audible alarm.
It is only possible to mute the battery discharge alarm,
which necessarily means that the device is running and
operating in battery mode. Any other warning or error alarm
cannot be muted.
Tab. 6. Functionality of the control panel buttons.
Information on
device faults
SPS ADVANCE R2 & T UNINTERRUPTIBLE POWER SUPPLY (UPS)
Description
Information on input
voltage and load %
Information on load
level connected to the
output (each segment is
equivalent to 25%)
Audible alarm unmute
49