Scheppach HBS261 Originalbetriebsanleitung Seite 42

Fault
Band saw blade jams when
working.
Motor runs but saw blade does
not move
19 EU Declaration of Conformity
Translation of the original Declaration of Conformity
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
We declare under our sole responsibility that the product
described here complies with the applicable directives
and standards.
Brand: SCHEPPACH
Art. designation: Band saw - HBS261
Item No. 5901514901
EU directives:
2014/30/EU, 2006/42/EC, 2011/65/EU*
2006/42/EG - Appendix IV
Notified body:
Number:
Certificate number:
* The object of the declaration described above fulfils the
regulations of the directive 2011/65/EU of the European
Parliament and Council from 8th June 2011, on the re-
striction of the use of certain hazardous substances in
electrical and electronic equipment.
Applied standards:
EN 62841-1:2015/A11:2022;
EN IEC 62841-3-5:2022/A11:2022;
EN IEC 55014-1:2021;
EN IEC 55014-2:2021;
EN IEC 61000-3-2:2019/A1:2021;
EN IEC 61000-3-3:2013/A2:2021
Documentation authorised representative:
Georg Kohler
Günzburger Str. 69
D-89335 Ichenhausen
Ichenhausen, 03.01.2025
Simon Schunk
Division Manager Product Center
Andreas Pecher
Head of Project Management
42 | GB
Possible cause
• Band saw blade blunt.
• Band saw blade resinous.
• Band saw blade guide
poorly adjusted.
Belt is not
correctly tensioned
TÜV SÜD
Product Service GmbH
Ridlerstraße 65
80339 München
0123
M6A0112840465 Rev.00
www.scheppach.com
Remedy
• Replace the band saw blade.
• Clean the band saw blade.
• Adjust the band saw blade guide.
Retighten belt