Scheppach MS225-56 Originalbetriebsanleitung Seite 36

• In the event of prolonged storage, empty the fuel tank
with a fuel extraction pump (not included in the scope
of delivery).
• In order to avoid fire hazards, keep the engine, ex-
haust pipe and the area around the fuel tank free of
grass, leaves and leaking grease (oil).
16.1 Preparing the lawnmower for long-
term storage
WARNING
Do not remove the fuel in enclosed spaces, near fire or
when smoking. Petrol fumes can cause explosions and
fire.
1. Drain the fuel tank (11) (see 14.4).
2. Carry out an oil change (see 14.3).
3. Remove the spark plug connector (16) from the spark
plug (16a).
Remove the spark plug (16a) using a spark plug span-
ner (see 14.6).
4. Fill the cylinder with approx. 0.2 l of oil from an oil can.
5. Pull the pull starter (25) slowly so that the oil protects
the inside of the cylinder.
6. Screw the spark plug (16a) back in.
7. Clean the cooling fins of the cylinder and the housing
(see 13).
8. Be sure to clean the entire product to protect the
paint.
9. Store the product in a well-ventilated place.
16.2 Fold the upper push bar (4)
together (Fig. 1)
WARNING
Risk of jamming!
Always hold the push bar with one hand at the highest
point.
– Never place fingers between the upper push bar
and the lower push bar.
For space-saving storage, the upper push bar (4) is fold-
able.
1. Remove the grass collection basket (23).
2. Unhook the pull starter (25) from the cable hook (24).
3. Open the quick clamp levers (5) on the lower push bar
(8).
4. Turn the quick clamp levers (5) at a right angle to the
push bar. To do this, you must move the quick clamp
levers (5) away from the lower push bar (8) slightly.
5. Move the upper push bar (4) down. The cables must
not be pinched in the process.
36 | GB
17 Repair & ordering spare parts
After repairs or maintenance, make sure that all safety-re-
lated parts are installed and are in perfect condition. All
parts which may cause injury must be kept where they
are inaccessible to children or others.
ATTENTION
According to the German Product Liability Act, no liabili-
ty is accepted for damage caused by improper repairs
or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialists. The same applies to
accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the front
page.
NOTE
Important note in the case of repairs
When returning the product for repair, for safety rea-
sons, ensure that it is free of oil and fuel when it is sent
to the service centre.
17.1 Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Blade - Article no.:
Engine oil - Article no.:
17.2 Service information
With this product, it is necessary to note that the following
parts are subject to natural or usage-related wear, or that
the following parts are required as consumables.
Wearing parts*: Spark plug, air filter, blade, V-belt
* = not included in the scope of delivery!
www.scheppach.com
7911200639
7850000025