Scheppach HMS1250 Originalbetriebsanleitung Seite 38

Workpiece feed
too slow during
thicknessing.
Chip ejection clogged
during thicknessing
(without extraction).
Chip ejection clogged
during jointing/planing
(without extraction).
Chip outlet clogged
with extraction during
jointing/planing or
thicknessing.
Optional accessories
Regular maintenance intervals
Checking the planing blades are in
flawless condition
Checking the correct functioning of
the safety equipment
Cleaning the machine of dust/chips
Checking the drive belts for tension
& condition/wear
Oiling/greasing all movable connecting parts
38 | GB
Workpiece was machined
against the direction of
growth.
Too much material planed
off at once.
Too much chip take-off.
Blunt blades.
Wood too wet.
Too much chip take-off.
Feed to fast.
Blunt blades.
Wood too wet.
Extraction too weak.
Check
Replace
Check
Replace
Clean
Check
Replace
www.scheppach.com
Clean the tabletop and treat it with a thin layer of sliding
wax.
Repair transport rollers.
Reduce chip take-off.
Replace blades.
Dry workpiece.
Reduce chip take-off.
Reduce feed speed.
Replace blades.
Dry workpiece.
An extraction unit that guarantees an air speed of at
least 20 m/s at the extraction connection, must be used.
HSS planing blade
Two-part set
Article number: 7902200610
EAN: 4014915231080
Before start up If
necessary
X
X
X
Weekly
X
X
X
X
X
After 6
months
X
X