Scheppach HMS1250 Originalbetriebsanleitung Seite 29

- Do not use the power tool for purposes for
which it is not intended.
- For example, do not use handheld circular
saws for the cutting of branches or logs.
8 Dress properly
- Do not wear wide clothing or jewellery, which
can become entangled in moving parts.
- When working outdoors, anti-slip footwear is
recommended.
- Tie long hair back in a hair net.
9 Use protective equipment
- Wear eye protection.
- Wear a mask when carrying out dust-creat-
ing work.
10 Connect the dust extraction device
- If connections for dust extraction and a col-
lecting device are present, make sure that
they are connected and used properly.
11 Do not use the cable for purposes for which it is
not intended
- Do not use the cable to pull the plug out of
the outlet. Protect the cable from heat, oil and
sharp edges.
12 Secure the workpiece
- Use the clamping devices or a vice
to hold the
In this manner, it is held more securely than
with your hand.
13 Avoid abnormal posture
- Make sure that you have secure footing and
always maintain your balance.
14 Take care of your tools
- Keep cutting tools sharp and clean in order to
be able to work better and more safely.
- Follow the instructions for lubrication and for
tool replacement.
- Check the connection cable of the power
tool regularly and have it replaced by a rec-
ognised specialist when damaged.
- Check extension cables regularly and replace
them when damaged.
- Keep the handle dry, clean and free of oil and
grease.
15 Pull the connector out of the socket
- When the power tool is not in use or prior to
maintenance and when replacing tools such
as saw blades, bits, milling heads.
workpiece in place.
www.scheppach.com
- If the planing shaft jams while working due
to excessive feeding force or the workpiece
jamming, switch the device off and disconnect
it from the mains. Remove the workpiece and
make sure that the planing shaft runs freely.
Switch the device on and carry out the cutting
operation again with reduced feeding force.
16 Do not leave a tool key inserted
- Before switching on, make sure that keys and
adjusting tools are removed.
17 Avoid inadvertent starting
- Make sure that the switch is switched off
when plugging the plug into an outlet.
18 Use extension cables for outdoors
- Only use approved and appropriately identi-
fied extension cables for use outdoors.
19 Remain attentive
- Pay attention to what you are doing. Remain
sensible when working. Do not use the power
tool when you are distracted.
20 Check the power tool for potential damage
- Protective devices or other parts with minor
damage must be carefully inspected to ensure
that they function correctly and as intended
prior to continued use of the power tool.
- Check whether the moving parts function
faultlessly and do not jam or whether parts
are damaged. All parts must be correctly
mounted and all conditions must be fulfilled to
ensure fault-free operation of the power tool.
- Damaged protective devices and parts must be
properly repaired or replaced by a recognised
specialist workshop, insofar as nothing differ-
ent is specified in the user instructions manual.
- Damaged switches must be replaced at a
customer service workshop.
- Do not use any power tool on which the
switch cannot be switched on and off.
21 ATTENTION!
- The use of other insertion tools and other ac-
cessories can entail a danger of injury.
22 Have your power tool repaired by a qualified
electrician
- This power tool conforms to the applicable
safety regulations. Repairs may only be per-
formed by an electrician using original spare
parts. Otherwise accidents can occur.
GB | 29