Scheppach HMS1250 Originalbetriebsanleitung Seite 27

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual package with the machine at
all times and store it in a plastic cover to protect it from dirt
and moisture. They must be read and carefully observed
by all operating personnel before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1-22)
1. Parallel stop
2a. Feed table
2b. Take-off table
3. Adjusting screw
4. Plunger
5. Chip extraction
6. Spindle
7. Planing table
8. Tool storage
9. On/off switch
10. Set screw
11. Planing blade cover, compl.
12. Clamping lever
13. Planing blade cover
14. Crank handle
15. Allen key
16. Clamping lever
17. Push stick
18. Guide bar
19. Fillister head screw
20. Anti-kickback claws
21. Overload switch
22. Fixing screw
23. Clamping screw
24. Cutter bar
25. Planing blade
26. Set screw
27. Mains cable
28. Cable holder
A. Scale (thickness plane)
B. Scale (infeed)
C. Scale (parallel stop)
3. Scope of delivery
• Jointer/planer/thicknesser 1x
• Push stick 1x
• Allen key 1x
• Crank handle 1x
• Parallel stop 1x
www.scheppach.com GB | 27