Scheppach HMS1250 Originalbetriebsanleitung Seite 28

• Clamping lever 1x
• Guide bar 1x
• Fillister head screw 2x
• Chip extraction 1x
• Operating manual
4. Proper use
The thicknesser/planer is used for planing and thick-
nessing of all types of edged sawn timber, with square,
rectangular or bevelled shape.
The machine may only be used in the intended
manner.
m WARNING!
The following work shall not be undertaken:
• Insert work (i.e. any machining that does not extend
over the entire length of the workpiece)
• Rebates, pegs or recesses
• Planing very curved wood where there is insufficient
contact with the feed table.
m It is strictly forbidden to dismantle, modify or change
the purpose of the guards on the machine or to fit other
guards.
The bridge guard must not be removed during ma-
chining. The unused part of the cutter shaft must be
covered.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
An element of the intended use is also the observance of
the safety instructions, as well as the assembly instruc-
tions and operating information in the operating manual.
Persons who operate and maintain the machine must
be familiar with it and must be informed about potential
dangers.
In addition, the applicable accident prevention regula-
tions must be strictly observed.
Other general occupational health and safety-related
rules and regulations must be observed.
The liability of the manufacturer and resulting damages
are excluded in the event of modifications of the machine.
The machine may only be operated with original parts
and original accessories from the manufacturer.
The safety, operating and maintenance specifications
of the manufacturer, as well as the dimensions speci-
fied in the technical data, must be observed.
28 | GB
Please observe that our equipment was not designed
with the intention of use for commercial or industrial
purposes. We assume no guarantee if the equipment
is used in commercial or industrial applications, or for
equivalent work.
The device is intended for use by adults. Children over
the age of 16 may use the tool except under supervision.
The manufacturer is not liable for damage caused by an
improper use or incorrect operation of this device.
5. General safety information
General safety information
Attention! The following basic safety measures must
be observed when using power tools for protection
against electric shock, and the risk of injury and fire.
Read all these notices before using the power tool and
store the safety instructions well for later reference.
Safe work
1 Keep the work area orderly
- Disorder in the work area can lead to acci-
dents.
2 Take environmental influences into account
- Do not expose power tools to rain.
- Do not use power tools in a damp or wet en-
vironment.
- Make sure that the work area is well-illumi-
nated.
- Do not use power tools where there is a risk
of fire or explosion.
3 Protect yourself from electric shock
- Avoid physical contact with earthed parts (e.
g. pipes, radiators, electric ranges, cooling
units).
4 Keep other persons away
- Do not allow other persons, especially chil-
dren, to touch the power tool or the cable.
Keep them away from your work area.
5 Securely store unused electric tools
- Unused power tools should be stored in a dry,
elevated or closed location out of the reach
of children.
6 Do not overload your power tool
- They work better and more safely in the spec-
ified output range.
7 Use the correct power tool
- Do not use low-output machines for heavy
work.
www.scheppach.com