Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English – 4
The braking power can change over time and a running-in
period may be necessary when the brakes are new or when
the brake pads have been replaced. For more information
about the braking system, refer to the brake manufacturer's
instruction manual.
During the journey
Adapt your riding style to the present riding situation, the
road conditions and your cycling abilities.
Please be aware that the ABS may increase your braking dis-
tance.
On slippery surfaces, the tyres skid more easily and there is
a greater risk of falling over. You should therefore reduce
your speed, applying the brakes in good time using a steady
pressure.
ABS indicator light
The ABS indicator light must come on after starting the
eBike and must go out again once you start riding at a speed
of approx. 5 km/h.
If the indicator light does not go out once you have started
riding or comes on while riding, this means that there is a
fault with the ABS or there is a shutdown of the ABS func-
tionality indicated by the user. If a display or on-board com-
puter is connected, you will also be shown an error code on
this. You can also view a saved error code on the eBike
Flow app. This means the ABS is no longer active. The brake
system will continue working, simply without the control
provided by the ABS.
Please make sure you have all repairs carried out by a
u
professional.
The functionality of the rear-wheel brake is not affected by
whether or not the ABS is working.
WARNING – ABS indicator lamp lit.
u
If the ABS indicator lamp is lit, this means that the ABS
function is disabled.
Note: The ABS indicator light may come on in extreme riding
situations where the front wheel and the rear wheel are turn-
ing at very different speeds, for example when riding solely
on the rear wheel or if a wheel is turning for an unusually long
period without making contact with the ground (assembly
stands). This will switch the ABS off. To re-enable the ABS,
stop the eBike and restart it (switch it off and on again).
CAUTION – faults with the ABS cannot be signalled if
u
the ABS indicator light is defective.
When starting the eBike, the rider must therefore check
to ensure that the ABS indicator light is lit; otherwise the
eBike will indicate a critical error by flashing red on the
operating unit. Contact a dealer if this happens.
Riding with the eBike battery drained
If the eBike battery's state of charge falls below a defined
threshold, the system will disable drive assistance first. The
eBike (including display and/or operating unit, light and
ABS) will nevertheless remain enabled until the eBike bat-
tery's reserve has been used up too. The eBike – and there-
0 275 008 3AS | (17.02.2024)
fore the ABS – will not switch off until the eBike battery is al-
most completely drained.
The indicator light will come on again for approximately five
seconds before the system switches off completely.
From this point onwards, the ABS indicator light will remain
off despite ABS control being unavailable. If the eBike is not
fitted with a battery or the eBike battery is drained, ABS is
disabled.
The brake system will continue working, simply without the
control provided by the ABS.
You will need to charge the eBike battery before you can re-
enable your eBike and the ABS function.
WARNING – ABS will be disabled without a power sup-
u
ply!
If the power fails, the battery is drained or the eBike bat-
tery is not fitted, the ABS will be disabled and the ABS in-
dicator light will not come on.
Maintenance and servicing
Maintenance and cleaning
Servicing and repairs must only be carried out by pro-
u
fessionals. Defective parts must always be replaced
with original parts.
Have your eBike checked by an expert at least once a year
(including mechanical parts, up-to-dateness of system soft-
ware).
Please have your eBike serviced and repaired by an author-
ised bicycle dealer.
Do not immerse any components, including the drive unit, in
water or clean them with pressurised water.
After-sales service and advice on using products
If you have any questions about the eBike and its compon-
ents, contact an authorised bicycle dealer.
For contact details of authorised bike dealerships, please
visit www.bosch-ebike.com.
Further information on the eBike components
and their functions can be found in the Bosch
eBike Help Center.
Disposal and substances in products
You can find information about substances in products at the
following link:
www.bosch-ebike.com/en/material-compliance.
Do not dispose of eBikes and their components with house-
hold waste.
An in-store return is possible, provided the retailer voluntar-
ily offers a return or is legally obligated to do so. Refer to the
national regulations in this case.
The drive unit, on-board computer incl. operat-
ing unit, eBike battery, speed sensor, ac-
cessories and packaging should be disposed of
in an environmentally correct manner.
Bosch eBike Systems
Werbung
