Limitations Of Use - TEUFELBERGER multiTOOL Gebrauchsanleitung

pic.8 Double strand
No use as a single strand!
The product meets the requirements of the ANSI
Z133-2017 standard for hitch cords (MBL ≥ 24,02kN
for the doubled hitch cord)
MODES OF USE - OD Loop 7mm T
pic.9 as single loop
The product meets the requirements of the ANSI
Z133-2017 standard as regards the required minimum
breaking load (MBL) for climbing ropes and prusik
loops. It does not meet the diameter requirements
use / limitations of use / to be observed prior to use
pic.10 as double loop
pic.11 as constriction loop
for climbing ropes. There exists no diameter re-
quirement for prusik loops.

3. LIMITATIONS OF USE

Never carry out work with this product if, as a result
of your physical and mental condition, your safety
might be compromised in scenarios of normal use
or in emergencies!
Do not run the product over sharp edges!
Care should be taken to ensure that the rope (or
any other part of the system) is routed away from
surfaces that may damage the rope (or any other
component), or that suitable and sufficient protection
is appropriately placed to ensure the rope and other
components are protected.
Keep away from surfaces which may cause damage
to the work equipment. The anchor device shall be
used for personal protective equipment and not for
lifting devices - as in rigging operations!
4. TO BE OBSERVED
PRIOR TO USE
Prior to every use, this product must be subject to
a visual inspection in order to verify its integrity,
readiness for use and proper functioning.
Once the product has been subject to a fall, its use
must be discontinued immediately. If the slightest
doubt remains, the product must be retired or may not
be used again until a duly compentent person, having
subjected such product to the required testing and
inspections, has approved its further use in writing.
It must be ensured that the recommendations for
use with other components be complied with: ropes
need to meet EN 1891, while carabiners need to
meet EN 362. Further PPE components must meet
the harmonized standards under the regime of
regulation (EU) 2016/425. Be sure to observe the
recommendations provided in this instructions for
use document and the specifications contained
in the "Documentation of Equipment". The com-
patibility of all components in the load chain is of
7