Inhaltsverzeichnis
Werbung
1
General provisions
1.1
Documentstobecompliedwith
•
Approval decision for CUBE tank
•
User manuals for delivery systems (e.g. pumps
and counters) from accessory manufacturers
•
User manual for overfill protection device (limit
indicator)
•
User manual for the leak sensor
•
The provisions of water law, industrial law and
building law must also be observed.
1.2
Application
The CUBE Tank 980 I is a factory-produced
container consisting of a roughly cubic internal
tank made in a rotation-moulding process, and a
surrounding outer container which serves as a col-
lection tray, together forming a container combina-
tion made from polyethylene (LLD-PE). The CUBE
Tank 980 I is intended for the non-pressurised
storage of:
•
Diesel fuel
•
Biodiesel
•
Lubricants
•
Pure urea solution 32.5% (e.g. AdBlue
other stored media in accordance with General
Technical Approval Z-40.21-589.
The permissible operating temperature is 40 °C.
The CUBE Tank 980 I is factory-fitted with a filling
and ventilating connection, as well as a delivery
system (pump, delivery hose and delivery valve), a
level indicator, and a leak detector.
2. Installation requirements
The installation requirements for the relevant
media can be found in the regulations under water
law, industrial law and building law. The containers
may only be installed in rooms within buildings and
in outdoor areas, but must not be used in poten-
tially explosive atmospheres in Zone 0 or 1. When
used in areas prone to flooding, the containers
must be positioned in such a way that the floodwa-
ter cannot reach them.
Prior to commissioning, the operator must affix a
sign to the container stating the name of the stored
fluid, its density and concentration.
3. Transport
In order to prevent mechanical damage, CUBE
tanks are supplied on a transport pallet and packed
in a protective film. To prevent damage and to
retain the right to claim under guarantee, the fol-
lowing must be observed at all times:
•
Transport and store only in original packaging
•
Do not drop or throw the tank
•
Do not place tank against edges or sharp
objects
) and
®
•
Do not remove transport packaging until tank is
placed at installation site
Should damage nevertheless occur, please report
this to our customer service team!
4. Installing the tank
When installing containers, please ensure good
stability. The container must stand so as to be level
and upright. The installation surface must be even
and have no edges or bumps. The surface must be
cleaned thoroughly prior to installation of the con-
tainer. Containers must be positioned at a sufficient
distance from walls, other structural elements and
one another to enable them to be checked visually
for fill level, leaks and condition at any time.
GB
29
Werbung
Inhaltsverzeichnis
