Inhaltsverzeichnis
Werbung
General technical approval /
General design certification
No. Z-40.21-589
(2) In addition, the manufacturer must clearly and permanently label the containers with
the following information on the outer wall of the collection container:
– Serial number;
– Date of manufacture,
– Nominal capacity of the container with a permissible fill level (as per Section 4.1.2) in litres,
– Material (it must be possible to identify the moulding compound and, where applicable, the
pigment used on the label, e.g. "PE-LLD – Resinex RX103") for inner and outer containers,
– Permissible operating temperature,
– Information concerning pressure-free operation,
– The note "Außenaufstellung zulässig" [Suitable for outdoor installation] or note
"Außenaufstellung nicht zulässig" [Not suitable for outdoor installation],
– The note "Nur für Lagermedien gemäß allgemeiner bauaufsichtlicher Zulassung/allgemeiner
Bauartgenehmigung Nr. Z-40.21-589" [Only for use with the storage media described in Gen-
eral technical approval/General design certification no. Z-40.21-589].
(3) The fill height corresponding to the maximum permissible fill level must be marked on
the container or the fill level indicator (maximum fill level mark).
2.4
Certificate of conformity
2.4.1
General provisions
(1) Confirmation of the compliance of the containers with the provisions of the General
technical approval included in the decision must be provided for each manufacturing plant in
the form of a declaration of conformity from the manufacturer, established on the basis of
factory production control and a certificate of conformity issued by a duly approved certifica-
tion body, together with the performance of regular external inspections by an approved in-
spection body, including an initial inspection of the containers in accordance with the follow-
ing provisions.
(2) The manufacturer of the containers must appoint a duly approved certification body and
a duly approved inspection body for the purposes of granting the certificate of conformity and
the external inspections, including the product inspections that must be carried out in this re-
gard.
(3) The declaration of conformity is to be provided by the manufacturer by means of the la-
belling of the building products with the conformity mark (Ü mark), together with a notice
concerning the intended use of the products.
(4) The certification body shall provide the Deutsches Institut für Bautechnik with a copy of
the certificate of conformity issued for information. The Deutsches Institut für Bautechnik
must also be provided with a copy of the initial inspection report for its information.
2.4.2
Factory production control
(1) Factory production control is to be established and performed in every manufacturing
plant. Factory production control is understood to be the ongoing monitoring of production by
the manufacturer to ensure that the containers that it manufactures are compliant with
the general technical approval included in this decision (Sections 1 and 2).
(2) The factory production control must include the inspections listed in Annex 4.
(3) The results of the factory production control must be recorded and evaluated. The records
shall at least contain the following information as a minimum:
– Description of the building product or the raw material;
– Type of check or inspection;
– Date of manufacture and date of inspection of the building product or the raw material or
its components;
– Results of the checks and inspections and comparison with the requirements;
– Signature of the person responsible for factory production control.
Z93472.21
Page 5 of 9 | 19 November 2021
GB
1.40.21-59/20
37
Werbung
Inhaltsverzeichnis
