Inspecting And Replacing The Fuses; Waste Disposal; The Weee Directive; Disposal Of The Packing Material - Keyline Ninja Vortex Bedienungsanleitungen

9.2.6

Inspecting and replacing the fuses

Spare part description Code
Slow fuse 6,3 A 5x20 RIC02990B
The NINJA VORTEX key duplicating machine is equipped with 2
fuses located in the power unit next to the switch, which have the
purpose to protect the machine from surges and short circuit.
If the machine fails to start after you have turned on the main
switch, we recommend you inspect the fuses in the power unit
and replace them if needed.
Required tools when replacing the fuses
• Tester, ohm meter, multimeter etc (to measure fuses' con-
tinuity).
• Screwdriver.
Before carrying out this operation disconnect the pow-
er cable from the mains.
How to proceed:
• press slightly on the tongues of the fuse carrier to pull it
out from its seat;
• inspect the fuses;
• replace any damaged fuse with a new one of the same ca-
pacity (Amperage) and type (slow);
• put back the fuse carrier into its seat.
22 Keyline S.p.A.
MAINTENANCE, DISMANTLING AND DISPOSAL
9.3.0

Waste disposal

The disposal of waste generated by the machine shall be managed
Frequency
in compliance with the legislation in force in the user's country. In
When required
Europe, machine shop rejections are classified as special waste
and are assimilated to metal wool when it comes to managing mu-
nicipal solid waste (MSW).
Such waste must be disposed of according to the legislation in
force in the user's country.
If machine shop rejections have been contaminated or contain
toxic or harmful substances they are considered as toxic-harmful
waste and disposed of accordingly in compliance with the legis-
lation in force.
The user is responsible for correct waste management.
9.4.0

The WEEE directive

When disposal becomes necessary, the NINJA VORTEX appliance
is to be considered as belonging to the WEEE category (Waste
Electrical and Electronic Equipment).
Keyline S.p.A. has always taken great care to protect the environ-
ment and complies with the legislative decree on WEEE that has
been in force since 13/08/2005. As a consequence, in accordance
with the prescriptions of directive 2002/96/CE, this appliance
cannot be disposed of as household waste (in compliance with
the special symbol shown below).
• Whoever disposes of this appliance illegally or as house-
hold waste will be subject to the sanctions foreseen by
current national legislation.
NINJA VORTEX
• According to the provisions of current national legislation,
this appliance cannot be disposed of as household waste.
Therefore, at the end of its lifecycle, after having carried
out the operations that are necessary for correct disposal,
the appliance must be taken to one of the differentiated
waste collection centres for electrical and electronic
waste from domestic households. Refer to the collection
centre in your own town, which will guarantee the function-
ality, accessibility and suitably of the differentiated collec-
tion systems, so that the final holder and distributors can
take the waste that they produce in their area to collection
centres, free of charge.
9.4.1

Disposal of the packing material

The packaging that contains the duplicator during transport is
made up of a cardboard box that can therefore be recycled as
packaging.
In the event of disposal it is considered as normal urban waste
and can be taken to the designated collection points for paper.
The machine protective covers are made of polymeric material
considered as MSW and are therefore disposed of in the appro-
priate plants.
Man. cod. B409959FG Copyright by Keyline - Italy