Modify And Cut; Decode; Code; Direct - Keyline Ninja Vortex Bedienungsanleitungen

7Modify and cut

7.1.0

Decode

This function makes it possible to decode a sample key after search-
ing for it with one of the methods described in the previous para-
graphs.
Warning: Important!
It is not possible to decode painted keys or keys made
of non-conductive materials.
How to proceed:
• From the key search sub-menu, select "
• Insert the original key in the jaws and lock it in place.
• Then follow the instructions on screen until the end of the
decoding process.
16 Keyline S.p.A.
MODIFY AND CUT
7.2.0

Code

This function makes it possible to input a specific code contained in
the data base and obtain the relevant coding.
How to proceed:
• From the key search sub-menu, select "
• Input the desired indirect code (e.g. A01) chosen among
those included in the range of numbers in the row below
(e.g. A000001-Z030198). When the code is recognised, it
turns blue; now select the desired row.
►
• Press " " to go to the "DIRECT" code input page (refer to
paragraph 7.3.0 on page 16).
►
• Then press " " to go to the following screen, the key
".
"CUTTING" one (for additional information, please refer to
paragraph 7.6.0 on page 18).
NINJA VORTEX
7.3.0

Direct

This function makes it possible to insert the bitting code for the key
directly.
How to proceed:
". • From the key search sub-menu, select "
• Input a value for each cut that shall correspond to the bit-
ting code.
►
• Then press " " to go to the following screen, the key
"CUTTING" one (for additional information, please refer to
paragraph 7.6.0 on page 18).
Man. cod. B409959FG
".
Copyright by Keyline - Italy