Maintenance, Dismantling And Disposal; General Information; Skills Of Maintenance Personnel; Type Of Maintenance - Keyline Ninja Vortex Bedienungsanleitungen

9Maintenance, dismantling and disposal

Warning: IMPORTANT!
Before carrying out any maintenance operation you
must turn OFF the power and disconnect the power cord.
Maintenance must be carried out only by qualified per-
sonnel equipped with appropriate protective devices
for safe work.
Always use original Keyline spare parts.
9.1.0

General information

9.1.1

Skills of maintenance personnel

The machine operator must be knowledgeable about machine operation.
9.1.2

Type of Maintenance

Ordinary Maintenance

• Servicing operations that must be carried out periodically
by the machine operator.
• The purpose of ordinary maintenance is guarantee regular
functioning of the machine and a consistent quality of the
product.
• The maintenance schedule may vary in relation to work or
environmental conditions in the place of installation.
Complex Maintenance
• Complex maintenance consists of actions to be taken only
when given conditions occur (break downs, failures, re-
placement of parts).
• Due to the complex nature of such actions and the special
tools required, we recommend you should contact quali-
fied personnel from or authorized by Keyline S.p.A.
9.2.0 Ordinary maintenance
We recommend inspecting the machine periodically and replace worn
parts.
9.2.1

Cleaning the working area

At the end of each working day clean the machine removing scrap and
burrs to ensure proper functioning of the machine and to prevent any
damage to its parts.
Copyright by Keyline - Italy
MAINTENANCE, DISMANTLING AND DISPOSAL
Empty the shaving collection drawer every time that the work
surface is cleaned or whenever it is full of shavings.
Do not clean the machine with compressed air.
9.2.2

Cleaning the display

To clean the Touch Screen display we recommend using a micro-
fibre cloth; avoid using substances that contain alcohol or sol-
vents.
9.2.3

Replacement of the cutter

• Press the button (2) and turn the knob (1) until the button
enters the locking area.
• Keeping the button pressed down (2), keep on turning the
knob (1) to remove the cutter
• Then use the cutter, positioning it flush to the spindle
• Turn the knob (1), keeping the button pressed (2), to lock
the cutter in the locking area.
1
2
NINJA VORTEX
9.2.4

Tracer points replacement

• Remove the tracer point grub screw (3).
• Remove the tracer point (4).
• Install the new tracer point, making certain that the groove
is aligned with the grub screw hole.
• Replace and tighten the grub screw to fasten the tracer point.
3
4
9.2.5

Head engraving tool replacement

• Loosen the locking screw (5) and remove the tool (6).
• Install the new engraving tool, bringing it flush and with the
flat side towards the locking screw.
• Tighten the locking screw (5).
6
5
Man. cod. B409959FG
3
4
Keyline S.p.A. 21