Werbung
Verfügbare Sprachen
Verfügbare Sprachen
insert the sealant cartridge (A) into
the corresponding compressor
compartment (F) and press it
down hard until you feel the
locking mechanism click. Remove
the speed limit sticker (D) and
apply it in a clearly visible position
wear the gloves
remove the tyre valve cap and
screw the transparent sealant
hose (E) onto the valve. Make sure
that the ON-OFF button is in the
off position (OFF position)
31
insert the electrical connector (H)
fig. 31 into the 12 V power socket
on the vehicle and start the engine
26
operate the compressor by
pressing the ON/OFF button
(ON position) fig. 30. When
the pressure gauge (B) reads
the prescribed pressure (see
the "Wheels" paragraph in the
"Technical data" chapter in the
Owner Handbook), switch off the
compressor by pressing the ON-
OFF button again
disconnect the cartridge (A) from
the compressor, by pressing
the release button (G) lifting the
cartridge upwards
If the pressure gauge (B) fig. 30
reads a pressure lower than 3
bar 15 minutes after turning on
the compressor, switch off the
compressor, disconnect the sealant
hose (E) from the tyre valve and
remove the cartridge (A) from the
compressor.
Move the vehicle approximately 10
F1A0742
metres to distribute the sealant.
Stop safely, engage the parking
brake and top up the pressure
to the prescribed value using the
black inflation pipe (C) fig. 30 . If
the pressure is still lower than 3 bar
15 minutes after switching on, do
not resume driving but contact a
Dealership. After driving for about
8 km / 5 miles, stop the vehicle in a
safe and suitable area, and engage
the parking brake.
Take the compressor and top up the
pressure using the black inflation hose
(C).
If the pressure reading is higher
than 3 bar, restore the pressure and
drive with great care to the nearest
Dealership.
Werbung
