Werbung
Verfügbare Sprachen
Verfügbare Sprachen
18
if the tool bag is not provided,
for special trim versions, a bag
containing the above tools may be
provided
for versions with alloy rims, remove
the snap-on hub cap
take the extension for spanner,
the bolt spanner and the rod for
spanner from the tool bag
with the tools correctly assembled,
loosen the bolts of the wheel to be
replaced by one turn
turn the ring nut to partially extend
the jack
position the jack at the lifting
support nearest the wheel to be
replaced, at the points shown
in fig. 19. For short wheelbase
versions with retractable
footboard, the jack must be
positioned at the lifting point
shown in fig. 20 aligned (45°) so
that it does not interfere with the
retractable platform
F1A0420
19
20
alert anybody nearby that the
vehicle is about to be raised. They
must stay clear and not touch the
vehicle it until it has been lowered
again
for versions equipped with self-
levelling pneumatic suspension,
before using the jack to raise the
vehicle, press the buttons (A) and
(B) fig. 21 simultaneously for at
least 5 seconds.
The operating mode for raising the
vehicle is activated: the LEDs on
the buttons come on constantly.
To exit this mode, press buttons
(A) and (B) simultaneously for
another 5 seconds; both LEDs
on the buttons will go out and full
system operation will be restored.
This mode is automatically
F1A0168
deactivated at speeds higher than
approximately 5 km/h
F1A0169
21
Werbung
