HBM PMX Bedienungsanleitung Seite 436

PMX command set (API)
434
bus­bits (p6) will be used to define the state of a digital
output.
p6: binary mask for the fieldbus­bits which is ANDed with
the 32 fieldbus­bits. If result is >0 (true) this digital output
will be set. A mask with more than one bit set is possible
too. Value range: 0,1,2,3...(2^32­1)
p7: enable for digital inputs (ON=1, OFF=0). If enabled
the status of the 16 digital inputs with the mask for the
digital inputs (p8) will be used to define the state of a di­
gital output.
p8: binary mask for the digital inputs which is ANDed with
the 16 digital inputs. If result is >0 (true) this digital output
will be set. A mask with more than one bit set is possible
too. Value range: 0,1,2,3...(2^16­1)
p9: enable for parameter­set­number (ON=1, OFF=0). If
enabled the parameter­set­number with the mask for the
parameter­set­number (p10) will be used to define the
state of a digital output.
p10: binary mask for the parameter­set­number which is
ANDed with the currently active parameter­set­number. If
result is >0 (true) this digital output will be set. A mask
with more than one bit set is possible too. Value range:
0,1,2,3...(2^32­1)
p11: enable for calculated­channel­bits (ON=1, OFF=0). If
enabled the status of the 32 bit word which can be
defined by one or more calculated­channel(s) in combina­
tion with the mask for the calculated­ channels (p12) will
be used to define the state of a digital output.
p12: binary mask for the calculated­channels which is
ANDed with the 32 calculated­channel ­bits. If result is >0
(true) this digital output will be set. A mask with more
than one bit set is possible too. Value range:
0,1,2,3...(2^32­1)
A3257-5.1 HBM: public
PMX