Werbung
TDD
Syntax:
Parameter:
p1
2
defines currently active parameterset as bootparameterset. This com
1
Load factory default into currently active parameter set and activate it.
Setting one parameterset to factory default (p1 = 1) sets all associated
sub parametersets to factory default. Be aware that these subparamet
0,1,2,...
Load parameterset p1 and activate it. If changing of the parameterset
has an error the response might be "OK" too. Please use TDD? to verify
p2
missing or 0
>0.1,...
(p1=2) has finished or timeout occurred. If parameterset is set to default
Note:
PMX
Transmit Device Data
Activate different amplifier settings (parameter sets)
TDD p1,p2(x)
p2 is optional
Saves all current parameters and parametersets of the device and
mand can take a plenty of time (e.g. 10...60s).
p2 will not be used. Command returns immediately.
ersets could be used in other parametersets too !!
the parameterset which is currently in use.
don't wait, no timeout detection, command responds immediately
Timeout in seconds. Waits until parameterset switching or saving
values (factory setup, p1 = 1) the timeout option p2 is not available!
PMX's parametersetsystem consists of subparameter
sets which
are linked together to one mainparameterset which can
be activated here (p1 >= 0).
A3257-5.1 HBM: public
Parameter set
response behavior / timeout
PMX command set (API)
411
Werbung
