HBM PMX Bedienungsanleitung Seite 406

PMX command set (API)
p5 F1+F2
p6 resolution
quadrupling
p7 physical
zero index
input
p8 factor
p9 pulses per
revolution
p10 offset in
pulses
p11 invert direc­
tion
p12 use interpol­
ation
Note:
404
0: Off /
1
(F2=90deg),
2 (F2=dir):
On
0: Off / 1: On
0: Off / 1 On Enables hardware (zero) input. If ON (every) zero­in­
0: Off Enables automatic resetting of counter after p8 rota­
(disabled) /
1,2,3,4: On
0: Off /
count­result of p9. A physical zero­pulse (p7) can reset
1...16000: On
the counter result too. Usually these possibilities are
0...16000 Reset­value of counter, usually not bigger than p9
0: standard
1: inverted
0: OFF
1: ON
This command automatically resets the current
counter­value to zero (NOT p10 !).
To reset the counter without changing the current settings
(parameterization has been done before) only p1 is ne­
cessary.
A3257-5.1 HBM: public
F1+F2 signal is evaluated
Evaluates only one or all edges
dex­pulse the counter­result is set to p10
If On, the counter is set to zero after reaching a
used in combination.
swaps counting direction
Similar to a filter, useful for slow pulses
tions (p8 *
p9 pulses)
PMX