HBM PMX Bedienungsanleitung Seite 440

PMX command set (API)
Syntax 2:
Parameter:
Response:
438
CodeSys­bits (p16) will be used to define the state of a
digital output. If CodeSys is not available, value is 0.
p16: binary mask for the CodeSys­bits which is ANDed
with the 32 CodeSys­application bits . If result is >0 (true)
this digital output will be set. A mask with more than one
bit set is possible too. Value range: 0,1,2,3...(2^32­1).
If CodeSys is not available, value is 0.
p17: enable for systemstatus­bits (ON=1, OFF=0). If en­
abled the status of the 32 bit systemstatus in combination
with the mask for the systemstatus (p18) will be used to
define the state of a digital output.
p18: binary mask for the systemstatus­bits which is AN­
Ded with the 32 systemstatus­bits. If result is >0 (true)
this digital output will be set. A mask with more than one
bit set is possible too. Value range: 0,1,2,3...(2^32­1)
q19: invert digital output (0: as described before, 1: inver­
ted)
SOP??(x)
none
q1,q2(y): available digital outputs (1..16)
A3257-5.1 HBM: public
PMX