Inhaltsverzeichnis
Werbung
the calibrations and dimensions must be adhered to.
• Relevant accident prevention regulations and other,
gene rally recognized safety-technical rules must also
be adhered to.
• The machine may only be used, maintained, and op-
erated by persons familiar with it and instructed in its
operation and procedures. Arbitrary alterations to the
machine release the manufacturer from all responsi-
bility for any resulting damages.
• The machine may only be used with original accesso-
ries and tools made by the manufacturer.
• Any other use exceeds authorization. The manufacturer
is not responsible for any damages resulting from un-
authorized use; risk is the sole responsibility of the
operator.
ADDITIONAL SAFETY INSTRUCTIONS FOR LASER LIGHT
The laser light and the laser radiation, which are used in
this system and have a maximum power of 390 μW and
wavelength of 650 nm, correspond to class 1. Normally,
these lasers do not pose any optical hazard, although
staring into the beam can lead to flash blindness.
Warning: Do not stare directly into the laser beam, as this
could pose a hazard. Observe the following safety instruc-
tions:
The laser may be used and maintained only in accord-
ance with the manufacturer's instructions.
• Point the beam only at the work piece and never at a
person or any other object.
• The laser beam must not be intentionally directed at
a person. It should never be directed at the eye of a
person for longer than 0.25 s.
• Always make sure that the laser beam is directed at a
sturdy work piece without reflective surfaces; in partic-
ular wood or materials with rough surfaces are accept-
able. Shining, reflective metal sheets or similar mate-
rials are not suitable for lasers, because the reflective
17
Werbung
Inhaltsverzeichnis
