Safety Goggles; Ear Protector; Adjusting The Muff Position; Adjusting The Temples - Parkside PBKS 53 B3 Originalbetriebsanleitung

GB

Ear protector

Adjusting the muff position

The muffs can be varied in height. Slide
the muffs into the appropriate position in
the guide on the headband. The muffs
should cover one ear at a time.

Safety goggles

Adjusting the temples

The temples can be adjusted in length.
Adjust the temples to the desired length by
pushing/pulling.
Transport
The goggles and ear protector should be
transported in a suitable protective cover
(e.g. case or soft bag) to avoid scratches
and damage.
Cleaning and
Maintenance
Safety goggles
- the safety goggles must be cleaned
with mild soap and lukewarm water
- dry the goggles with a clean cotton
cloth.
- Do not leave to dry near heat sources.
- disinfect the safety goggles frequently,
but do not use solvents.
Ear protector
- Clean the ear protector with a damp
cloth. Do not use any cleaning agents
or solvents that could damage the ma-
terial.
14
- If the sealing pads are damaged or
can no longer be cleaned, replace the
ear protector.
Maintenance and
storage
Safety goggles
If the goggles are scratched or damaged,
replace the entire item. We recommend
storing these safety goggles in an appro-
priate protective cover when you are not
using them.
Store in a dry and well-ventilated place out
of reach of sunlight, chemicals and cleaning
agents.
Ear protector
Store the ear protector in a dry, dust-free
and well-ventilated place out of reach of
sunlight, chemicals and cleaning agents.

Online shop

You can obtain spare parts from
www.grizzlytools.shop
Waste Disposal
and Environmental
Protection
The products and packaging should be
properly recycled.