Appendix For Software Version P85 Updated 19.07.2004 - HBM WE2108 Serie Referenzhandbuch

Scale electronic unit (NSW)
12
(delayed tilt-display)
An active tilt signal must be present for the time set by DLT command before the ,tiLt'-state is
dispayed. When there is no tilt signal, display returns to weighing mode immediately. Setting
DLT0 (ex works) means that there is no tilt delay.
The used input has to be configured for tilt switch mode, according to manual part 1, section
5.6 .
(High resolution value)
Output of internal measured values at increased speed
Output at 10−fold resolution has the following characteristics:
•
•
•
•
•
•
•
•
Example:
WE2108
Appendix for software version P85
DLT
HRV
Command:
Query:
Parameter:
Password protection: no
Parameter backup:
Query is possible at any time using the new HRV command. There is no specific operat-
ing mode.
Response length: 8 ASCII characters (sign and 7 digits)
COF format has no effect
There is neither a comma nor a measuring unit
Resolution always amounts to one tenth of the valid increment (see example)
Toggling between two−range and two−division scale is taken into account.
No value is output in the event of an overflow, the response to HRV? then is −−−−−−−−
(depending on the Legal−for−trade mode, overflow starts from nominal (rated) value +
9 d or from 135 %)
The tare value will not be output. Query is possible using TAV? or the msv command with
net mode and cof12. The tare value is output at standard resolution.
Scale settings: nominal value 30.00, 5−digit increment.
Standard display = 0.00; 0.05; ... 29.95; 30.00
Output with HRV:
No comma, nominal value = 10−fold nominal value of scale, rounded off to 5−digit incre-
ments.
Output: 0000000; 0000005,...0029995; 0030000
not available
HRV?;
−−
−−
updated 19.07.2004
127
HBM