Safety; Use For The Intended Purpose; Possible Misuse; Working Safely - Signode BXT3-13 Originalbetriebsanleitung

2

Safety

2.1

Use for the intended purpose

These tools are intended for the strapping of packaged items such as packets, pallet loads etc. The
tools are intended for strapping with plastic packaging straps (polypropylene and polyester) (Section
7).
2.1.1

Possible misuse

Strapping with steel straps is not permitted with these tools.
Lifting, hanging and pulling of packaged goods by the straps is not permitted.
The tools must not be modi ed without prior authorisation.
2.2

Working safely

The operating instructions must always be available at the place of operation of the strapping tool.
They must be read and observed by all persons working with or on the strapping tool.
Preventive and corrective maintenance on the tool may only be carried out by trained personnel.
In addition to the operating instructions, the applicable rules for accident prevention and safe and
professional work must be observed.
The operator is responsible for safe strapping and the correct strap selection for the package, depend-
ing on its dimensions, weight, edges and stability and the way it will be transported and stored.
Only the strap dimensions (Section 7) speci ed for the tool type should be used. The tools should be
adjusted appropriately for the strap used and the package (Section 4). The operator is responsible for
the correct tool settings.
Wear protective equipment
When operating the tool, wear eye and hand
protection (cut-proof gloves) and safety shoes.
2.3

Safety instructions

WARNING
These hazards can result in serious injuries.
Strap tensioning or strapping, danger of jamming and crushing
Do not place hands or other body parts between the strap and the packaged goods during
the strapping process. Ensure that there are no other persons in the hazard zone.
For an emergency stop in the case of danger (trapped person):
To release the strap tension (before welding), actuate the rocker lever. In operating
mode AUTO, also the tensioning or welding button can be pressed again.
After welding, break the strap at the welded seal or cut it using a tool.
Loose and falling packaged goods in the case of faulty strapping
Check the weld seal. Never transport packaged goods with strapping that has not been
performed properly.
Electric power
Before use, always inspect the plug and cable of the charger, and have it replaced by a
specialist if it is damaged.
Risk of explosion in EX zones
The tool must not be used in areas where an explosive atmosphere may occur.
V 02.16
SIGNODE BXT3-13/16/19
31 of 53
ENGLISH