Introduction; Device Description - Scheppach SD1600V Original Bedienungsanleitung

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Failure to comply with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed.
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1-16)
1. Blow-off device
2. Mounting (blow-off device)
3. Knurled screw
4. Holder (saw blade guard)
5. Saw blade guard
6. Saw table
7. Fine-wire fuse
8. Cover, left
9. Storage box
10. Bearings
11. Tightening lever
12. Arm
13. Graduated scale
14. Knurled nut
15. Suction connection
16. On/off switch
17. Speed regulator
18. Assembly points (premounted rubber feet)
19. Work lamp
20. ON / OFF switch work lamp
21. Saw blade
22. Allen key 3 mm
23. Retaining device
24. Screw (depressor)
25. Table inlay
26. Saw blade holder, top
27. Upper saw blade clamping screw
28. Lower saw blade clamping screw
29. Saw blade holder, bottom
30. Angle bracket (not included in the scope of deliv-
ery)
31. Screw (graduated scale pointer)
32. Pointer
33. Screw (left cover - front)
34. Screw (left cover - rear)
35. Adjustment screw with locknut
www.scheppach.com GB | 25