Fitting Instructions - Respekta CH 24060 SAM Bedienungsanleitung

5.3.2 Fitting instructions

Important:
The distance between the underside of the hob and the top of any kitchen unit or appliance beneath it
(3) must be at least 50 mm.
WARNING: If the hob is installed over an oven, make sure the oven is a fan-assisted
model.
1 1 2 2
4 4
1) - Worktop
2) - Sealing tape
3) - Minimum clearance
4) - Brackets
5) - Electric hob
6) - Screws
Installation steps
1) - Remove the protective film from the pre-installed sealing tape (2).
2) - Place the hob (5) in the worktop cut-out and press gently.
3) - Secure the four fixing brackets (4) to the underside of the hob (5) with screws (6).
CAUTION: Do not apply excessive pressure to the hob to avoid the risk of damaging it.
en-42
5 5
6 6
3 3
Fig. 5.2